User manual M-SYSTEM MVW651

[. . . ] Safety information Product description Control panel First use Set the water softener Use of dishwasher salt Use of rinse aid Daily use Load cutlery and dishes Use of detergent Select and start a washing programme 45 46 47 48 48 49 50 51 52 54 55 Subject to change without notice Unloading the dishwasher Washing programmes Care and cleaning What to do if. In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] Mix spoons with other cutlery to prevent them from sticking together. For best results we recommend that you use the cutlery grid provided (if the size and dimensions of the cutlery allow it). Before closing the door, ensured that the spray arms can rotate freely. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Arrange items on and underneath the cup racks so that water can reach all surfaces. To move to the higher position proceed as follows: 1. Carefully lift both sides upwards until the mechanism is engaged and the basket is stable. Glasses with long stems can be placed upside down in the cup racks. For taller items, the cup racks can be folded upwards. Close the dishwasher door, the programme starts automatically. Setting and starting the programme with delay start The start of the washing programme will be delayed by 3 hours. Once the door is closed the countdown will continue from the point at which it was interrupted. Hot steam may escape when the door is opened. Close the door; the programme will start from the point at which it was interrupted. cancel a washing programme in progress · Open the dishwasher door; press the programme selection/cancel button for about 3 seconds, until the light of the running programme goes off and the End indicator light flashes. If a new washing programme is to be selected, check that there is detergent in the detergent dispenser. The indicator light of the programme just ended remains on. Leave the dishwasher door ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. The dishes should therefore be allowed to cool down before removing from the appliance. ⷠEmpty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. ⷠWater may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. [. . . ] to the sink outlet spigot , securing it to the underside of the work surface. This will prevent waste water from the sink running into the machine. The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. The drain hose can face either to the right or left of the dishwasher Ensure the drain hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]