User manual MA LIGHTING DIGITAL DIMMER WM 03-2005

[. . . ] Digital Dimmer WM User's Manual 03. 2005 Contents 1. The menus 4. 1 The main menu (top menu) 4. 2 The channel menu (2nd menu) 4. 3 The Memory menu (3rd menu) 4. 4 The Setup menu (supervisor menu) 4. 4. 1 DMX Fail (reaction on failing DMX signal) 4. 4. 2 DMX MODE 4. 4. 3 CLEAR CURVES 4. 4. 4 USER MODE (limiting the dimmer control) 4. 4. 5 DELETE ALL 4. 4. 6. and 4. 4. 7 CURVE USER (creating user-defined trigger curves) 4. 4. 8 PHASE CORR. Startup 6. 1 Mains connection and earthing 7. [. . . ] -SUPER In the , , Superuser" mode, you can use all of the functions. -NORM In the , , Normal user" mode, you can only set the DMX address from the Channel menu. You should chose this mode, if you want to avoid inadvertently modifying the dimmer, while still being able to use the testing or staging function and setting the DMX address (express rental / tour). Hotline. : + 49 5251 688865-99. User's Manual Digital Dimmer WM 05. 2005 13 -LOCK The dimmer is completely locked and cannot be controlled using the keys and the Encoder. Exception: enter the Setup menu by holding down the middle key for 5 seconds. In this menu, you can then switch modes again. The DMX signal will still function normally. 4. 4. 5 DELETE ALL Hold down the MENU button for 5 seconds. Rotate the Encoder, until DELETE ALL is selected. Hold down the right button and rotate the Encoder. , , Delete All" will delete all contents and defined values like, e. g. The DMX address will be set to 1 and the Block mode will be activated. Limit will be set to 100% and Preheat to , , 0". Caution: The defined data will be deleted irretrievably ! 4. 4. 6. and 4. 4. 7 Creating CURVE USER (user-defined trigger curves) Here, you can activate the Setting menu for trigger curve 1 or 2. This will allow you to define individual brightness curves according to specific fixtures or tastes. You can assign these curves separately for each dimmer channel. Hold down the MENU button for 5 seconds. Rotate the ENCODER, until the CURVE USER 1 line or CURVE USER 2 line is marked. In the Curve menu, use the Encoder to change the position for the X axis (input); while holding down the right key, you can modify the Y axis (output). The defined values will be displayed as % on the respective axis (INPUT + OUTPUT). The displayed output will refer to the LIMIT setting (can be set in the CHANNEL menu). the curve is on 50% output, and if you have entered a limit of 60% for this channel, the , , real" output will just be 30%. Use the left key (SAVE) to save the setting and exit menu. [. . . ] Power cord or plug are damaged or frayed. The device was exposed to rain (or wet conditions of other forms). The device does not function properly when abiding by the instructions of use. Do only adjust controls mentioned in the instructions, as an improper setting of other controls can cause damage; very often, it takes quite some time for the customer service technician to repair damages like these. [. . . ]