User manual MACH SPEED MS945G-GLV

[. . . ] Setup Manual FCC Information and Copyright This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. The vendor makes no representations or warranties with respect to the contents here and specially disclaims any implied warranties of merchantability or fitness for any purpose. [. . . ] CPU Overheated If the system shutdown automatically after power on system for seconds, that means the CPU protection function has been activated. When the CPU is over heated, the motherboard will shutdown automatically to avoid a damage of the CPU, and the system may not power on again. The CPU cooler surface is placed evenly with the CPU surface. CPU fan speed is fulfilling with the CPU speed. After confirmed, please follow steps below to relief the CPU protection function. Remove the power cord from power supply for seconds. Plug in the power cord and boot up the system. (See "Close CMOS Header: JCMOS1" section) 2. Power on the system again. 20 Motherboard Manual 4. 4 1. TROUBLESHOOTING Probable No power to the system at all 1. Power light don't illuminate, fan inside power supply does not turn 2. Indicator light on keyboard does not turn on. Solution Make sure power cable is securely plugged in. Contact technical support. 2. System inoperative. Keyboard lights are on, power indicator lights are lit, and hard drive is spinning. Using even pressure on both ends of the DIMM, press down firmly until the module snaps into place. Check cable running from disk to disk controller board. Make sure both ends are securely plugged in; check the drive type in the standard CMOS setup. Backing up the hard drive is extremely important. All hard disks are capable of breaking down at any time. Re-install applications and data using backup disks. System does not boot from hard disk 1. drive, can be booted from optical drive. 2. System only boots from optical drive. Hard disk can be read and applications can be used but booting from hard disk 2. Screen message says "Invalid Configuration" or "CMOS Failure. " Cannot boot system after installing second hard drive. Review system's equipment. [. . . ] This property can make [WarpSpeederTM] utility more robust. 29 Motherboard Manual APPENDENCIES: SPEC IN OTHER LANGUAGE GERMAN Spezifikationen LGA 775 CPU Intel Core2Duo/ Pentium 4 / Pentium D / Celeron D Prozessoren mit bis zu 3, 8 GHz FSB Chipsatz 533 / 800 /1066 MHz Intel 945G ITE 8712F Super E/A Intel ICH7 Umgebungskontrolle, Unterstützt Hyper-Threading / Execute Disable Bit / Enhanced Intel SpeedStep® / Extended Memory 64 Technology Bietet die häufig verwendeten alten Hardware-Überwachung Super E/A-Funktionen. Low Pin Count-Schnittstelle DDR2 DIMM-Steckplätze x 4 Lüfterdrehzahl-Controller "Smart Guardian"-Funktion von ITE Dual-Kanal DDR2 Speichermodul Unterstützt DDR2 533 / 667 registrierte DIMMs. Nicht-ECC DIMMs werden nicht unterstützt. Arbeitsspeic Jeder DIMM unterstützt her 256/512MB & 1GB DDR2. 4GB Arbeitsspeicher Integrierter IDE-Controller IDE Ultra DMA 33 / 66 / 100 Bus Master-Modus SATA II Integrierter Serial ATA-Controller Datentransferrate bis zu 3Gb/s Realtek RTL 8110SC / RTL 8100C (optional) Unterstützt PIO-Modus 0~4, Konform mit der SATA-Spezifikation Version 2. 0. [. . . ]