User manual MACKIE LOGIC 7 SURFACES SUPPORT

[. . . ] Logic 7 Dedicated Control Surface Support Apple Computer, Inc. Under the copyright laws, this manual may not be copied, in whole or in part, without the written consent of Apple. Your rights to the software are governed by the accompanying software licence agreement. The Apple logo is a trademark of Apple Computer, Inc. , registered in the U. S. [. . . ] Any existing track automation data (of the current fader type) will be replaced by new movements as long as the control is active--i. the fader is being touched or V-POT is being turned. LATCH--Similar to Touch mode, but the control remains activated, even when the fader is no longer being "touched" or V-POT being turned. In other words, following the release of the fader, the current fader value will replace the existing automation data for as long as the sequencer is in playback mode. WRITE--Overwrites all existing automation data, or creates new automation data. Only use it if you wish to destroy all existing automation data. TRIM--Not enabled in the release version of Logic 5. Please consult the readme files of updated versions. Chapter 2 Logic Control--Details 53 When the OPTION key is held down, pressing one of the Automation buttons chooses the selected automation mode for all tracks. When an automation mode has been selected for all tracks, the button's LED will illuminate whenever the OPTION key is held. N. B. --This is slightly different for the "Off" automation mode, when holding down the OPTION button. While doing so, all automation "writing" buttons will be turned off, but this does not necessarily mean that all tracks are actually in Off mode--they could also be in different modes. To ensure that you have set all tracks to Off mode, press READ/ OFF twice (its LED goes on, then off ), while holding down the OPTION key. Group Pressing the GROUP button enters Group Edit Mode: · GROUP button's LED is on · The Assignment display shows the currently displayed group, e. g. · The Time display shows the group name (10 last characters if name is longer than 10 characters) · The upper LCD line displays track names · The lower LCD line displays group parameters · Group parameters can be toggled with V-SELECTs · CURSOR UP/DOWN selects previous/next group · CURSOR LEFT/RIGHT shifts group parameter display · SELECT buttons display if a track is a member of the group. Pressing a SELECT button toggles track membership of the group With Group Edit Mode off, holding down GROUP and pressing one or more SELECT buttons allows you to create a new group. Pressing the GROUP button, while the SHIFT button is held down, creates a new group, opens the Group window and enters Group Edit mode. Pressing the GROUP button, while the TRACK button is held down, switches to Track Multi Channel View, displaying the Track Group parameter. It displays which group the instrument is a member of. Multiple group membership is displayed like in the Track Mixer window. Turning a V-POT changes group membership. Note that you can only select one group (or "Off") here. 54 Chapter 2 Logic Control--Details Utilities Buttons Save Saves the current Song file. When pressed, a file save dialog will open on your computer screen, waiting for you to enter a filename as per usual. The Logic Control LCD will display There is a file select dialog and the Position/Time Display will show ALErt. [. . . ] F0 00 00 66 10 12 00 48 65 6C 6C 6F F7 Notes: · There are 7 displayed characters per channel, with the exception of channel 8, which displays only the first 6 characters. Internally however, the LCD stores 2 x 56 characters. · In most cases you will use the LCD in a scribble-strip fashion (text above each channel). In this case, you should use only the first six characters per channel to leave space between channel text. [. . . ]