User manual MACKIE SRM350V2

[. . . ] SRM350v2 Active SOUND ReiNFORceMeNt SPeAKeR USeR'S MANUAL IMPORTANTSAFETYINSTRUCTIONS 1. Donotblockanyventilationopenings. Installinaccordancewiththe manufacturer'sinstructions. Donotinstallnearanyheatsourcessuchasradiators, heatregisters, stoves, orotherapparatus(includingamplifiers)thatproduceheat. Donotdefeatthesafetypurposeofthepolarizedorgrounding-type plug. Apolarizedplughastwobladeswithonewiderthantheother. [. . . ] Therefore, leave the MIC/LINE switch out on the following SRM50vs in the chain. PLACEMENT The SRM50v active speakers are designed to sit on the floor, a tabletop, or to fit on a standard tripod speaker stand. They can also be suspended by the rigging points, which requires installing the optional hanging bracket on the top and/or bottom of the cabinet (SRM350v2 Bracket Kit: Part No. NEVER attempt to suspend the SRM50v active speakers by their handles. You can lay the cabinet down on its side and use the SRM50v as a floor monitor. The asymmetrical trapezoidal shape of the cabinet provides a perfect angle for aiming up toward performers from the front of the stage. As with any powered components, protect them from moisture. If you are setting them up outdoors, make sure they are under cover if you expect rain. Do not place it closer than two feet (0. 6 meters) from any TV set or computer monitor. Check the screen for any change in color or distortion. Do not place any magnetic audio or video tapes or computer discs near the SRM50v. RoomAcoustics The SRM50v active speakers are designed to sound as neutral as possible; that is, to reproduce the input signal as accurately as possible, monitoring the sound rather than changing it. Room acoustics play a crucial role in the overall performance of a sound system. However, the wide high-frequency dispersion of the SRM50v helps to minimize the problems that typically arise. SLEEVE SLEEVE TIP TIP TIP (HOT) SLEEVE (SHIELD) Balanced XLR Connectors Top 900 RING SLEEVE SLEEVE RING TIP TIP RING (COLD) TIP (HOT) 900 Dispersion up to 20 kHz SLEEVE (SHIELD) Balanced TRS Connectors 10 Here are some useful placement tips: · Avoid placing loudspeakers in the corners of a room. This increases the low-frequency output and can cause the sound to be muddy and indistinct. · Avoid placing loudspeakers against a wall. This, too, increases the low-frequency output, though not as much as corner placement. However, if you do need to reinforce the low frequencies, this is a good way to do it. · Avoid placing the active speakers directly on a hollow stage floor. A hollow stage can resonate at certain frequencies, causing peaks and dips in the frequency response of the room. It's better to place the active speakers on a sturdy table or tripod stands. · Position the active speakers so the high-frequency drivers are to feet above ear level for the audience (make allowances for a standing/dancing in the aisles audience). High frequencies are highly directional and tend to be absorbed much easier than lower frequencies. By providing direct line-of-sight from the active speakers to the audience, you increase the overall brightness and intelligibility of the sound system. · Highly reverberant rooms, like many gymnasiums and auditoriums, are a nightmare for sound system intelligibility. [. . . ] · Use a dry cloth to clean the cabinets. Only do this when the power is turned off. Avoid getting moisture into any of the openings of the cabinet, particularly where the drivers are located. NeedhelpwithyournewSRM350v2?· Visitwww. mackie. comandclickSupporttofind: FAQs, manuals, addendums, andotherusefulinformation. [. . . ]