User manual MAGIC CHEF MCWC30MCG

[. . . ] 2 3 4 5 5 7 8 10 CAUTION: Read and follow all safety rules and operating instructions before first use of this product. Wine Cooler Thank you for buying this appliance. We hope it will successfully serve your requirements for many years. This appliance is intended for storing bottled wine in the temperature range of 5. 5 to 19. 0 / 41. 9 o F to 66. 2 o F. SAVE THESE INSTRUCTIONS 2 Before Putting Into Use . To Assemble Door Handle Instructions for Use Tips for Energy Savings Important . 3 Disposing of Worn Out Appliances Placing and Installation . [. . . ] Perishable items should be stored towards the back/rear of the shelves. (B) Defrost Water Outlet The interior of the appliance is cooled with a cooling plate mounted in the rear wall. Under the plate there is a channel and an outlet for defrost water. Regularly check the defrost water outlet and the drain channel for blockage. They should always be kept free and clean of particles. WE RESERVE THE RIGHT TO ALTER THE SPECIFICATIONS WITH NO EFFECT ON THE OPERATION OF THE APPLIANCE. Temperature Control The temperature of the appliance is controlled by setting the thermostat knob to a desired setting. Temperature Selection To start the appliance turn the temperature control knob to the position corresponding to the desired cooling. Fig A (MCWC16MCG) see page 6 Fig B (MCWC30MCG) see page 6 The temperature will vary depending on the quantity of the item stored and on the frequency with which the door is opened. To turn the control to the "OFF" position, rotate the control knob to the "0" position. If the appliance has been left out of use for some time, set the control to maximum or the "7" position for 2-3 hours before turning to the desired position. If the appliance is not being used for long time periods, disconnect the plug and leave the door partially open. This will help to reduce mold/mildew from accumulating inside the appliance cabinet. Warning: Never set the temperature control to maximum or "7" position for more than 8 hours. 5 CONTROL KNOB Fig A (MCWC16MCG) Fig B (MCWC30MCG) . Changes in ambient room temperature will affect the internal temperatures (choose correct setting of the thermostat knob). In STOP (0) position the appliance does not operate (cooling system is switched off ), yet power supply is not interrupted. Temperature in the appliance also depends on how often the door is opened. THERMOSTAT DIAL: For controlling the temperature inside the wine cooler. Turns the motor on as soon as the temperature rises above the desired level. PLASTIC COATED OR CHROMED SHELVES: Odor resistant, rustproof, and removable for easy cleaning. MAGNETIC GASKET: Tight fitting door seal keeps all the cooling power locked inside. TEMPERED GLASS DOOR & INTERIOR LIGHT: Allows easy interior visibility. (Interior light for MCWC30MCG only) TEMPERATURE RANGE GUIDE: MIN. Upper-Section 19. 0 /66. 2 F 17. 0 /62. 6 F 13. 6 /56. 4 F 0 0 0 Mid-Section 17. 0 /62. 6 F 14. 0 /57. 2 F 9. 8 /49. 6 F 0 0 0 Lower-Section 14. 0 /57. 2 F 10. 0 /50. 0 F 5. 5 /41. 9 F 0 0 0 The above temperatures may fluctuate between +/- 5 . 6 Maintenance and Cleaning Automatic Defrosting of the Appliance There is no need to defrost the cooler , because ice depositing on the inner back wall is defrosted automatically. [. . . ] Make sure the door assembly is properly aligned on the cabinet before tightening the screws. 7. Remove the door handle and re-install on the opposite side. 8 . Remove the plug buttons from the right doorframe and transfer them to the uncovered holes at the left side. Be sure to press the plug buttons firmly into the holes. [. . . ]