User manual MAGIMIX NESPRESSO M300

[. . . ] Removable water tank Cup heating plate On/Off switch Capsule holder Spout ring Grill Drip-tray with indicator for water level H : Steam / hot water knob i : Display j : Pivotal steam/hot water nozzle with integrated frothing attachment k : Cleaning tool with discharging bit and spiral) l : Hexagonal key (for removal of the capsule cage) Pour toute information concernant les différentes variétés de café Nespresso et pour commander les capsules, adressez-vous à votre Nespresso Club, dont l'adresse figure sur votre machine ou dans le «Welcome-pack». Une fois en place, la poignée doit se présenter face à vous ou très légèrement décalée vers la droite (4) Placez un récipient suffisamment large sous le porte-capsule et un second sous la buse vapeur/eau chaude (5) Appuyer sur la touche afin de mettre l'appareil en marche (6). WARNING: Always replace the fuse cover of the fitted plug, never use the plug With the fuse cover omitted. Read these instructions carefully before using your Nespresso machine. [. . . ] Displaying the number of cups Press the key /P until the word CUPS appears on the display. Release the key and the number of cups now appears on the flashing display. Descaled display Press the key /P until DECALC appears on the display. Release the key and the number of descaling operations effected flashes on the display. Access to the programming mode To access the programming mode, the machine must be connected to the power supply. Setting the language Press the key /P until LANGUAGE appears on the display. Press the key /«+» or /«-» to access this programming point. Now press the key /«+» or /«-» until the desired language appears. confirm the entry by pressing the key /P. You may choose between D/F/I/E/NL/Sp/Port. TAP CLOSE When you draw off warm water to reduce the steam temperature, this message is displayed after the machine has automatically interrupted the process of drawing off water. This message appears when the cup filling quantity is being programmed. - Make sure that there is enough water in the tank. - Clean the capsule holder as described under «Cleaning» - Press the key or with the capsule holder inserted but without coffee capsules; When READY is displayed on the display you can prepare your coffee normally. If the message does not disappear - clean the needle cage as described under «Cleaning». Replace the capsule holder on the capsule cage and tighten until the handle is facing you or slightly offset towards the right Place the preheated cup (see «preheating cups») under the «coffee» outlet Depending on the choice of cup, (large or small), press or (11). 0 dl of coffee The machine stops automatically when the desired filling level is reached. Remove the full cup, remove the capsule holder and the used capsule (12) You can reduce the filling quantities set in the factory or those you have programmed yourself by briefly pressing either of the keys or before the automatic cutout occurs. This will not affect the programmed settings. Note: if a power failure occurs, the values set in the factory and those programmed by you are memorized. WAIT The machine has not yet reached the necessary operating temperature. eNGLISH READY The machine has reached the necessary operating temperature. [. . . ] Manually screw the capsule cage back into the spout ring with the help of the hexagonal key. Do not use the capsule holder to handle this procedure!The best possible foam will be obtained with skimmed milk Use a rather narrow and tall receptacle, if possible a small chromium-plated steel jug To obtain milk foam, air is essential. Do not immerse the nozzle too deeply into the milk. [. . . ]