User manual MAGNEPAN CC SPEAKER STAND

[. . . ] Magneplanar CC (Center Channel) Speaker Stand Table of Contents 1. General Description Carton Contents Packaging Installation and Adjustments Hookup Phasing and Processor Settings Bass Attenuation Service and Shipping Specifications General Description The Magneplanar CC Speaker Stand is both a speaker stand and a midbass/bass woofer to augment the low frequencies for Magneplanar center channel speakers. [. . . ] Whenever possible, place the CC Speaker Stand and your center channel speaker equi-distance to the listener with your left/right Magneplanars. Hookup 1. Connect your amplifier to the input at the bottom of the CC Speaker Stand (observing polarity). Using a short section of speaker wire, connect from the CC Speaker Stand output at the top of the CC Speaker Stand to your Magneplanar center channel speaker (observing polarity). Phasing and Processor Settings Set your processor on "large" center channel speaker. As an option, the center channel of the processor can be set on "small" with a crossover setting of 40-50 Hz. As a precaution, we recommend that you check the phasing between the CC Speaker Stand and the Magneplanar center channel speaker by reversing the speaker cables to the center channel speaker. The shaped pink noise test CD included with your CC Speaker Stand will aid in confirming that the CC Speaker Stand is in-phase with your Magneplanar center channel speaker. A reduction in output in the 90-100 Hz peak will indicate an out-of-phase condition. A technique which can aid in determining if the phase is correct is by leaning over and positioning your head equidistance between the Magneplanar center channel speaker and the CC Speaker Stand as shown in Fig. The left and right ears are equi-distance to the respective speakers. High frequencies will appear to be up and low frequencies will appear to be down. The 90-100 Hz peak, if in phase, will appear to be in the middle (and louder). Using a multi-channel test disk, recheck the phase between the center channel speaker and the left/right speakers. Fig. 4 Bass Attenuation In the unlikely event that the CC Speaker Stand has too much bass relative to your Magneplanar center channel speaker, a power resistor can be inserted in place of the jumper. A power resistor of ___ watts should be used if attenuation is needed. [. . . ] Frequency Response: 50 Hz-5 kHz (wide-band response) Recommended Power: See F. A. Q. on web site www. magnepan. com Sensitivity: _____dB @2. 83V/1 Meter/50 Hz Impedance: 4 Ohms Dimensions: Warranty: Limited 3-year to original owner Shipping Weight: ___ lbs. [. . . ]