User manual MAKITA 1050D

[. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. [. . . ] For rough cutting, the depth of cut can be increased, while for a good finish you should reduce the depth of cut and advance the tool more slowly. Always switch off the tool before insertion or removal of the battery cartridge. â· To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. â· To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. â· Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. Use the edge fence when shiplapping (rabbeting) or cutting workpieces nearly 50 mm wide. Install the edge fence on the tool and secure it with the washer and thumb screw (A). Loosen the thumb screw (B) and adjust the edge fence until it comes in contact with the side of the workpiece. Then tighten the thumb screw (B) securely. You may wish to add to the length of the fence by attaching an extra piece of wood. Convenient holes are provided in the fence for this purpose. When planing, move the tool with the edge fence flush with the side of the workpiece. CAUTION: Before shiplapping, make sure that the blade end protrudes slightly from the side of the drum. Turn the knob on the front of the tool until the pointer is aligned with the desired cutting depth on the scale. CAUTION: The knob can be turned beyond the 0. [. . . ] Mini planer blade Hex wrench Edge fence (Guide rule) with thumb screw and washer Dust bag Plastic carrying case Various type of Makita genuine batteries and chargers However, if you notice that the blade edge is below the level of the rear base or protrudes too far from the rear base, proceed as follows. Turn the pan head screws clockwise to retract the blade or counterclockwise to protrude it. After adjusting the blade height, tighten the two installation bolts securely. [. . . ]