User manual MAKITA 108

[. . . ] €¢ Specifications and battery cartridge may differ from country to country. Be sure that you understand their meaning before use. Remove the lock key before inspecting, adjusting, cleaning, servicing, leaving and storing the equipment. Cd Ni-MH Li-ion 2002/96/EC on waste electric and electronic equipment, 2006/66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ] Make sure the cord is secured with the cord holder. 7) Open out the battery hood and then slide all the way and click the product mounting adapter of the BCV01 into the battery port 1. 8) Pull up lightly and remove the rubber cap from the slit in the lower housing as shown in the figure. NOTE: • Do not pull up the rubber cap forcibly because forcing it may damage its retaining section. 9) Bend the cord of the battery converter BCV01 over the product attachment section. Then run the cord of the BCV01 through the slit in the lower housing and close the battery hood. To remove the BCV01, follow the installation procedure in reverse. 10) Open the battery hood and click in the BCV02 into the battery port. To remove the BCV02, press on the hook of the BCV02 and withdraw it with both hands. €¢ When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not operate. In these cases, charge the battery or replace the empty battery with a fully charged one. This may cause the cord to be entangled by the blade, resulting in damage to the tool and a personal serious injury. €¢ When using the BCV01, never attach it to any part of your body. Attaching the BCV01 to any part of your body may cause a serious injury. 5) Hook the battery converter BCV01 onto installation section of the handle. Holder (optional accessory) When using the BCV01, be sure to use the holder (optional accessory) to retain its cord. 6) Fit the holder (optional accessory) in the hole on the left side of the handle from the operator’s view. And then push the cord into the holder so that the cord tension is 10 • Do not forcibly rotate the blade, or hit it with a hammer, the tool may be damaged. If there is a obstacle stuck on the blade, remove it carefully. Turn on the main switch, and check the red light is off. Power switch action WARNING: • Before inserting the battery cartridge in the tool, always check to see that the switch lever actuates properly and returns to the original position when released. Operating a tool with a switch that does not actuate properly can lead to loss of control and serious personal injury. [. . . ] Have repairs made on any damaged or missing parts. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. TROUBLE SHOOTING Problem Neither the battery lamp nor the warning lamp lights up even after pressing the main switch. possible cause Battery cartridge is not installed. [. . . ]