User manual MAKITA 109

[. . . ] Be sure that you understand their meaning before use. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. Only for EU countries Do not dispose of electric equipment or battery pack together with household waste material!In observance of European Directive 2012/19/EU on waste electric and electronic equipment, 2006/66/EC on batteries and accumulators and waste batteries and accumulators and their implementation in accordance with national laws, electric equipment and battery pack that have reached the end of their life must be collected separately and returned to an environmentally compatible recycling facility. [. . . ] Battery protection system Lithium-ion batteries are equipped with a protection system. This system automatically cuts off power to the tool to extend battery life. • The strokes per minute vary by the conditions of battery cartridge and shear blades. In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded. Then pull the switch trigger again to restart. If the tool does not start, the battery is overheated. In this situation, let the battery cool before pulling the switch trigger again. €¢ Low battery voltage: The remaining battery capacity is too low and the tool will not operate. In this situation, remove and recharge the battery. 2) The handle can be rotated to either 90° left or right and mounted either 45° or 90° position to fit your work needs. First, pull the knob and rotate the handle clockwise or counterclockwise in the direction of arrow as shown in the figure. The length of the arm cord hook band is adjustable. NOTE: • Do not pass the extension cord through the band. €¢ Do not force the opening of the holder. failure to do so may cause deflection and damage to it. €¢ When only the lowermost indicator lamp (next to the “E”) blinks, or when none of the indicator lamps light, the battery capacity has run out, so the tool does not operate. In these cases, charge the battery or replace the empty battery with a fully charged one. €¢ When two or more indicator lamps do not light even after charging is complete, the battery has reached the end of its service life. €¢ When the upper two and lower two indicator lamps light alternately, the battery may have malfunctioned. contact your local Makita authorized service center. NOTE: • The indicated capacity may be lower than the actual level during use or immediately after using the tool. €¢ Depending on the conditions of use and the ambient temperature, the indication may differ slightly from the actual capacity. [. . . ] After operation, remove dust from both sides of the blade with wired brush, wipe off it with a rag and then apply enough low-viscosity oil, such as machine oil etc. 12 NOTE: • When the shear blades does not operate properly, there is a poor fit between the blades and crank. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. [. . . ]