User manual MAKITA 109HS

[. . . ] Of drive links Number of teeth Overall length Net weight Rated voltage BUC250 8. 36 V GEB071-6 • Weight, with battery cartridge, according to EPTA-Procedure 01/2003 ENE031-2 CORDLESS CHAIN SAW SAFETY WARNINGS: 1. Keep all parts of the body away from the saw chain when the chain saw is operating. Before you start the chain saw, make sure the saw chain is not contacting anything. [. . . ] In this situation, remove and recharge the battery. ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. Installing or removing saw chain CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the saw chain. €¢ Always wear gloves when installing or removing the saw chain. 7) Press the lever and with the lever pressed in, turn it counterclockwise to loosen the nut until sprocket cover comes off. (Pressing in the lever leads to the fitting of lever into the nut. 8) Turn the adjusting dial counterclockwise to release the saw chain tension. Remove the saw chain and guide bar from the chain saw. To install the saw chain, fit in one end of the saw chain on the top of the guide bar and the other end of it around the sprocket. Battery remaining capacity indicator (only for models with Battery BL3622A) Battery BL3622A is equipped with the battery remaining capacity indicator. 6) Press the CHECK button to indicate the battery remaining capacity. The length of the arm cord hook band is adjustable. NOTE: • Do not pass the extension cord through the band. €¢ Do not force the opening of the holder. €¢ The way of removing or installing a battery cartridge from or on the battery adapter is the same as that of removing or installing it from or on the tools. €¢ Press down the hook securely as far as it will go when the battery adapter is hooked on the waist belt and similar objects. 20 WORKING WITH THE CHAIN SAW The first time user should, as a minimum practice, do cutting logs on a saw-horse or cradle. Burrowing and parallel-to-grain cuts CAUTION: • Burrowing and parallel-to-grain cuts may only be carried out by persons with special training. The possibility of kickback presents a risk of injury. perform parallel-to-grain cuts at as shallow an angle as possible. Carry out the cut as carefully as possible, as the serrated rail cannot be used. 30) Pruning trees CAUTION: • Keep all parts of the body away from the saw chain when the motor is operating. [. . . ] Have the sprocket replaced in this case. The sprocket need to be installed so that it always faces as shown in the figure. Always fit a new locking ring when replacing the sprocket. Replace when they wear down to the limit mark. [. . . ]