User manual MAKITA 115I

[. . . ] Don’t forget that it forms an integral part of the machine, so keep it handy so that it can be consulted at any time, and pass it on to the purchaser if you resell the machine. This new machine of yours has been designed and made in line with current regulations, and is safe and reliable if used for cutting and collecting grass exactly following the instructions given in this manual (proper usage). ) se réfèrent au modèle “122” . Since the product is continually being improved, you may find slight differences between your machine and the descriptions contained in this manual. [. . . ] € A loose blade causes unwanted vibrations and can be dangerous. Do not use the machine if you are unsure whether it is working safely or efficiently. If in doubt, contact your Dealer immediately to make the necessary checks and repairs. All starting operations have to be effected in an open or well HOW TO USE THE MACHINE EN 25 ventilated area! aLWAYS REMEMBER THAT EXHAUST GASES ARE TOXIC!To start the engine: – open the fuel stopcock (1) ( ➤ (if fitted); – put the transmission into neutral («N») (☛ 4. 1 When the engine has started, put the accelerator in the «SLOW» position and close the choke ( ➤ if fitted). IMPORTANT The choke must be closed as soon as the engine is running smoothly. Using when the engine is already warm can foul the spark plugs and cause the engine to run erratically. NOTE Should you have difficulties in starting do not persist with using the starter motor as this can run down the battery or flood the engine. Turn the key to the «OFF» position, wait for a few seconds and then repeat the operation. Gradually release the pedal to engage the clutch and then begin moving in reverse. ž For hydrostatic drive models: When the machine is stopped, start the reverse movement by pressing the drive pedal in the «R» direction (☛ 4. 5 GRASS CUTTING When you have reached the area to be mowed, Ø 100 make sure that the grass-catcher or stone-guard is Ø 80 correctly fitted and that the cutting deck wheels are positioned at the required height. 1 Each wheel can be fitted at two different heights: the low position always leaves a space between the ground and the edge of the cutting deck to prevent 2 the deck from damaging the lawn if the ground is uneven. The higher position excludes this possibility. To change the position, unscrew and remove the pin (1) then reposition the wheel (2) in the upper and lower hole of the wale corresponding to the wheel diameter. This work is to be done to all four wheels, WITH THE ENGINE OFF AND THE BLADES DISENGAGED. To start cutting: – – – – put the accelerator into the «FAST» position; bring the cutting deck to the highest position; engage the blades (☛ 4. 9); start moving forwards onto the grass area very gradually and with particular caution, as already described; – adjust the forward speed and the cutting height (☛ 4. 10) according to the lawn condition (height, density and dampness of the grass). When cutting on sloping ground, the forward speed must be reduced to ensure safe conditions ( ☛ 1. [. . . ] €CB01” MAINTENANCE BATTERY-CHARGER This makes it possible to keep the battery in good working order when the machine is in storage, guaranteeing an optimum level of charge and a longer life to the battery. KIT FOR “MULCHING” (only on prearranged models) It finely chops the grass cuttings and leaves them on the lawn, instead of collecting them in the grass-catcher. 102) Improves grass collecting when the cutting deck is close to the ground. From 216 to 240 kg ➤ For mechanical drive models: Forward speed (approximate) at 3000 min. [. . . ]