User manual MAKITA 120SIH

[. . . ] PARTS COVERED Listed below are the parts covered by the Emission Components Defect Warranty. Some of the parts listed below may require scheduled maintenance and are warranted up to the first scheduled replacement point for that part. Fuel Metering System Carburetor and internal parts Fuel filter, if applicable Throttle stopper, if applicable Choke System, if applicable Air Induction System Pre filter, if exist Air filter, Air filter case, Intake manifold Ignition System Spark plug Flywheel Magneto Ignition Coil Miscellaneous Items Used in Above Systems Fuel hoses, clamps and sealing gaskets OBTAINING WARRANTY SERVICE To obtain warranty service, take your engine to the nearest DOLMAR service Center authorized by DOLMAR. The dealer of service authorized by DOLMAR will perform the necessary repairs or adjustments within a reasonable amount of time and furnish you with a copy of the repair order. [. . . ] Make sure the log will not roll down-hill. If on a slope, stand on the up-hill side of the log (see fig. Shattered wood should be cut very carefully. Sharp slivers of wood may be caught and flung in the direction of the operator of the saw. 31 Limbing Limbing is removing the branches from a fallen tree. There is an extreme danger of kickback during the limbing operation. Be extremely cautious and avoid contacting the log or other limbs with the nose of the guide bar. 30 Start limbing by leaving the lower limbs to support the log off the ground (fig. A pinch may result or the limb may fall, causing loss of control. If a pinch occurs, stop the engine and remove the saw, by lifting the limb. The limbs could spring back toward the operator and cause loss of control of the saw or injury to the operator. Do not operate this chain saw unless you have extraordinary cutting needs and experience and specialized training for dealing with kickback. Chain saws with significantly reduced kickback potential are available. 18 PUTTING INTO OPERATION CAUTION: Before doing any work on the guide bar or chain, always switch off the engine and pull the plug cap off the spark plug (see „Replacing the spark plug“). CAUTION: A Do not start the saw until it has been completely assembled and inspected!Use the universal wrench delivered with the chain saw for the following work. Carefully spread the sprocket guard (3), pull it from its fixture (4) and remove it. 4 B 3 Remove the plastic transport cover A and dispose of properly. Turn the chain adjusting screw (5) to the left (counter­clockwise) until the pin (6) is at the left stop. a C 6 5 Position the guide bar (7). Make sure that the pin (8) of the chain tightener is in the hole on the guide bar. 7 D 8 19 Lift the chain (9) over the sprocket (10). [. . . ] Please contact your nearest service center (list enclosed). Reliable long-term operation, as well as the safety of your chain saw, depend among other things on the quality of the spare parts used. Use only original DOLMAR parts, marked Only original spare parts and accessories guarantee the highest quality in material, dimensions, functioning and safety. Original spare parts and accessories can be obtained from your local dealer. [. . . ]