User manual MAKITA 1900B

[. . . ] Cluttered areas and benches invite injuries. Do not use power tools in damp or wet locations. Do not use power tools where there is risk to cause fire or explosion. Avoid body contact with earthed or grounded surfaces(e. g. [. . . ] Form the habit of checking to see that keys and adjusting wrenches are removed from the tool before turning it on. Do not carry a plugged-in tool with a finger on the switch. When tool is used outdoors, use only extension cords intended for outdoor use. Do not operate tool when you are tired. 6 20. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury. Have your tool repaired by a qualified person. Tighten the three hex flange head bolts (with the socket wrench provided) and hand rotate the drum to check clearances between the blade ends and the tool body. ADDITIONAL SAFETY RULES ENB045-2 1. 17. Rags, cloth, cord, string and the like should never be left around the work area. Inspect for and remove all nails from the workpiece before operation. Be sure the blade installation bolts are securely tightened before operation. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced blade. Make sure the blade is not contacting the workpiece before the switch is turned on. Wait until the blade attains full speed before cutting. Keep at least 200 mm away from the tool at all times. Always switch off and wait for the blades to come to a complete stop before any adjusting. Never stick your finger into the chip chute. [. . . ] 10) First, rest the tool front base flat upon the workpiece surface without the blades making any contact. Switch on and wait until the blades attain full speed. Apply pressure on the front of tool at the start of planing, and at the back at the end of planing. Planing will be easier if you incline the workpiece in stationary fashion, so that you can plane somewhat downhill. [. . . ]