User manual MAKITA 2414ENE

[. . . ] Be careful not to damage the spindle, flanges (especially the installing surface) or bolt, or the wheel itself might break. Keep guards in place and in working order. Make sure the wheel is not contacting the workpiece before the switch is turned on. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. [. . . ] FUNCTIONAL DESCRIPTION CAUTION: • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 2) CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. For tool with lock-off button To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. To start the tool, depress the lock-off button and pull the switch trigger. To remove the wheel, loosen the clamping screw, hold the safety guide by both hands and raise it, then slide the safety guide towards yourself. Press the shaft lock so that the wheel cannot revolve and use the socket wrench to loosen the hex bolt by turning it counterclockwise. Then remove the hex bolt, outer flange and wheel. (Note: Do not remove the inner flange, ring and O-ring. ) To install the wheel, follow the removal procedures in reverse. CAUTION: • Be sure to tighten the hex bolt securely. Insufficient tightening of the hex bolt may result in severe injury. Use the socket wrench provided to help assure proper tightening. €¢ Always use only the proper inner and outer flanges which are provided with this tool. €¢ Always lower the safety guard after replacing the wheel. 3) The spark guard is factory-installed with its lower edge contacting the base. Operating the tool in this position will cause many sparks to fly around. Loosen the screw and adjust the spark guard to a position at which minimum sparks will fly around. 12, 13, 14, 15 & 16) By turning the vise handle counterclockwise and then flipping the vise nut to the back, the vise is released from the shaft threads and can be moved rapidly in and out. To grip workpieces, push the vise handle until the vise plate contacts the workpiece. Flip the vise nut to the front and then turn the vise handle clockwise to securely retain the workpiece. CAUTION: • Always set the vise nut to the front fully when securing the workpiece. Failure to do so may result in insufficient securing of the workpiece. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. €¢ Abrasive cut-off wheels • Socket wrench 17 NOTE: • Some items in the list may be included in the tool package as standard accessories. They may differ from country to country. ENG905-1 ENH003-14 For European countries only EC Declaration of Conformity We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Portable Cut - off Model No. [. . . ]