User manual MAKITA 2414NB

[. . . ] The use of improper accessories may cause risk of injury to persons. Serious injury could occur if the tool is tipped or if the cutting tool is unintentionally contacted. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function - check for alignment of moving parts, binding of moving parts, breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced. [. . . ] Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. Watch out for flying sparks when operating. Remove material debris from the area that might be ignited by sparks. Be sure that others are not in the path of the sparks. Keep a proper , charged extinguisher closely available. Do not attempt to keep the trigger in the ON position. If the wheel stops during operation, makes an odd noise or begins to vibrate, switch off the tool immediately. Turn off the tool and wait for the wheel to stop before moving workpiece or changing settings. Do not touch the workpiece immediately after operation; it is extremely hot and could burn your skin. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. Bolt holes The spark guard is factory-installed with its lower edge contacting the base. Operating the tool in this position will cause many sparks to fly around. Loosen the screw and adjust the spark guard to a position at which minimum sparks will fly around. This tool should be bolted with two bolts to a level and stable surface using the bolt holes provided in the tool's base. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. When a new wheel is installed, set the stopper plate to position (A). When the wheel wears down to the extent that the lower portion of the workpiece is left uncut, set the stopper plate to position (B) to allow increased cutting capacity with a worn down wheel. Remove the two hex bolts which secure the guide plate. Move the guide plate as shown in the figure and secure it using the hex bolts. [. . . ] Should any trouble develop during this one year period, return the COMPLETE tool, freight prepaid, to one of Makita's Factory or Authorized Service Centers. If inspection shows the trouble is caused by defective workmanship or material, Makita will repair (or at our option, replace) without charge. This Warranty does not apply where: · repairs have been made or attempted by others: · Repairs are required because of normal wear and tear: · This Warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. [. . . ]