User manual MAKITA 3621

[. . . ] Router MODEL 3621 003251 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Collet capacity Plunge capacity No load speed (RPM) Overall length Net weight 3621 1/4" 35 mm (1-3/8") 29, 000/min. 211 mm (8-5/16") 2. 4 kg (5. 3 lbs) · Manufacturer reserves the right to change specifications without notice. [. . . ] Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. Be careful of the bit rotating direction and the feed direction. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. 14. Always lead the power supply cord away from the tool towards the rear. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. Draw attention to the need to use cutters of the correct shank diameter and suitable for the speed of the tool. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Follow material supplier safety data. SAVE THESE INSTRUCTIONS WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. SYMBOLS The followings show the symbols used for tool. V . . . . . . . . . . . . . . . . . . . . . . . alternating current USD201-2 n . . . . . . . . . . . . . . . . . . . . no load speed ° . . . . . . . . . . . . . . . . . . . . Class II Construction . . . /min. . . . . . . . . . . . . . . . revolutions or reciprocation per minute 5 FUNCTIONAL DESCRIPTION · CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. 003252 Adjusting the depth of cut Place the tool on a flat surface. Loosen the screw securing the stopper pole. 1 2 1. Screw 003253 Loosen the lock lever and lower the tool body until the bit just touches the flat surface. Tighten the lock lever to lock the tool body. 1 1. Depth pointer Screw Stopper pole Adjusting hex bolt Stopper block Next, lower the stopper pole until it makes contact with the adjusting hex bolt. Align the depth pointer with the "0" graduation. Raise the stopper pole until the desired depth of cut is obtained. The depth of cut is indicated on the scale (1 mm or 1/16'' per graduation) by the depth pointer. Then tighten the screw to secure the stopper pole. Now, your predetermined depth of cut can be obtained by loosening the lock lever and then lowering the tool body until the stopper pole makes contact with the adjusting hex bolt. CAUTION: Since excessive cutting may cause overload of the motor or difficulty in controlling the tool, the depth of cut should not be more than 15 mm (9/16") at a pass when cutting grooves with an 8 mm (5/16") diameter bit. [. . . ] 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Dr. Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Ste. 101 San Antonio, TX 78219 (210) 228-0676 MASSACHUSETTS 232 Providence Hwy. Westwood, MA 02090 (781) 461-9754 COLORADO 11839 E. [. . . ]