User manual MAKITA 3708F

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Collet chuck capacity No load speed (RPM) Overall length Net weight 3708 / 3708F 1/4" 35, 000/min. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Wear hearing protection during extended period of operation. Check the bit carefully for cracks or damage before operation. Inspect for and remove all nails from the workpiece before operation. Make sure the bit is not contacting the workpiece before the switch is turned on. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. Be careful of the bit rotating direction and the feed direction. Always switch off and wait for the bit to come to a complete stop before removing the tool from workpiece. Do not touch the bit immediately after operation; it may be extremely hot and could burn your skin. Always lead the power supply cord away from the tool towards the rear. Do not smear the tool base carelessly with thinner, gasoline, oil or the like. Draw attention to the need to use cutters of the correct shank diameter and which are suitable for the speed of the tool. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. To adjust the bit protrusion, loosen the lever and move the tool base up or down as desired by turning the adjusting roller. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. CAUTION: With the tool unplugged and switch in the "OFF" position, rotate the collet nut on the tool several times to be sure that the bit turns freely and does not contact the base or trimmer shoe in any way. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. CAUTION: Before plugging in the tool, always be sure that the tool is switched off. â· Switch can be locked in "ON" position for ease of operator comfort during extended use. [. . . ] Radius of circles to be cut (distance between the center of circle and the center of bit) are as follows: Min. The straight guide is effectively used for straight cuts when chamfering or grooving. Attach the guide plate to the straight guide with the bolt, the wave washer, the flat washer and the wing nut. Attach the straight guide with the clamp screw (A). [. . . ]