User manual MAKITA 3709X

[. . . ] ENGLISH Trimmer MODEL 3709 006612 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Collet chuck capacity No load speed (min-1) Overall length Net weight Safety class 3709 6 mm or 1/4" 30, 000 199 mm 1. 5 kg /II · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. SYMBOLS END201-2 The following show the symbols used for the tool. [. . . ] If damaged, have the power tool repaired before use. Many accidents are caused by poorly maintained power tools. 21. Use the cor- erly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to control. 22. Use the power tool, accessories and tool rect power tool for your application. The correct power tool will do the job better and safer at the rate for which it was designed. 17. Do not use the power tool if the switch does not turn it on and off. Any power tool that cannot be controlled with the switch is dangerous and must be repaired. 18. in accordance with these instructions and in the manner intended for the particular type of power tool, taking into account the working conditions and the work to be performed. Use of the power tool for operations different from those intended could result in a hazardous situation. Service 23. Have your power tool serviced by a quali- the plug from the power source and/or the battery pack from the power tool before making any adjustments, changing accessories, or storing power tools. Such preventive safety mea- fied repair person using only identical replacement parts. This will ensure that the safety of the power tool is maintained. ADDITIONAL SAFETY RULES 1. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Wear hearing protection during extended period of operation. 7. ENB054-1 Check the bit carefully for cracks or damage before operation. Replace cracked or damaged bit immediately. Inspect for and remove all nails from the workpiece before operation. Keep hands away from rotating parts. 2. 9. Make sure the bit is not contacting the workpiece before the switch is turned on. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate improperly installed bit. 13. [. . . ] Place the templet guide on the base and replace the base protector. Then secure the base protector by tightening the screws. 1. Screwdriver 005435 1 2 Secure the templet to the workpiece. Place the tool on the templet and move the tool with the templet guide sliding along the side of the templet. [. . . ]