Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MAKITA 4304. We hope that this MAKITA 4304 user guide will be useful to you.
Lastmanuals help download the user guide MAKITA 4304.
Detailed instructions for use are in the User's Guide.
[. . . ] Ordinary eye or sun glasses are NOT safety glasses. Inspect workpiece for any nails and remove them before operation. Check for the proper clearance beyond the workpiece before cutting so that the blade will not strike the floor, workbench, etc. Make sure the blade is not contacting the workpiece before the switch is turned on. [. . . ] 4) CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. The tool speed can be adjusted between 500 and 3, 000 strokes per minute by turning the adjusting dial. the dial is marked 1 (lowest speed) to 6 (full speed). Refer to the table below to select the proper speed for the workpiece to be cut. However, the appropriate speed may differ with the type or thickness of the workpiece. In general, higher speeds will allow you to cut workpieces faster but the service life of the blade will be reduced. For 4304 only Press the trigger and at the same time move the lock lever backward. To stop from this lock position, press the trigger and release it. Rest the base flat on the workpiece and gently move the tool forward along the previously marked cutting line. When cutting curves, advance the tool very slowly. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). loosen the bolt on the bottom of the tool. Move the base so that the bolt is positioned in the center of the crossshaped slot in the base. Use of the circular guide insures clean, smooth cutting of circles (radius; under 200 mm. Insert the pin through the center hole and secure it with the threaded knob. Move the base of the tool forward fully. Then install the circular guide on the base in the same manner as the guide rule (rip fence). The vacuum head is recommended to perform clean cutting operations. Install the plastic cover on the tool by fitting it into the notches in the tool. To attach the vacuum head on the tool, insert the hook of the vacuum head into the hole in the base. [. . . ] To trim edges or make dimensional adjustments, run the blade lightly along the cut edges. Always use a suitable coolant (cutting oil) when cutting metal. failure to do so will cause significant blade wear. The underside of the workpiece can be greased instead of using a coolant. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA 4304
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA 4304 will begin.
