Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual MAKITA 4306. We hope that this MAKITA 4306 user guide will be useful to you.
Lastmanuals help download the user guide MAKITA 4306.
Detailed instructions for use are in the User's Guide.
[. . . ] Make sure that the back edge of the blade fits into the roller. Then tighten the screw to secure the blade. 3)
CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF” position when released. 3)
Press the trigger and at the same time move the lock lever backward. [. . . ] 14)
Use of the circular guide insures clean, smooth cutting of circles (radius: under 200 mm). Insert the pin through the center hole and secure it with the threaded knob. Move the base of the tool forward fully. Then install the circular guide on the base in the same manner as the rip fence (guide rule). 5 & 6)
With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). Loosen the bolt on the bottom of the tool. Move the base so that the bolt is positioned in the center of the cross-shaped slot in the base. Tilt the base until the desired bevel angle is obtained. Then tighten the bolt to secure the base. 15, 16 & 17)
The vacuum head is recommended to perform clean cutting operations. Install the plastic cover on the tool by fitting it into the notches in the tool. To attach the vacuum head on the tool, insert the hook of the vacuum head into the hole in the base. The vacuum head can be installed on either left or right side of the base. Then connect a Makita vacuum cleaner to the vacuum head. 7)
Loosen the bolt on the bottom of the tool and move the base all the way back. Then tighten the bolt to secure the base. Cutouts
Cutouts can be made with either of two methods A or B. A) Boring a starting hole: For internal cutouts without a lead-in cut from an edge, pre-drill a starting hole more than 12 mm in diameter. Insert the blade into this hole to start your cut. 8) Plung cutting: You need not bore a starting hole or make a lead-in cut if you carefully do as follows. [. . . ] 12)
For splinter-free cuts, the anti-splintering device can be used. 13)
When cutting widths of under 150 mm repeatedly, use of the rip fence (guide rule) will assure fast, clean, straight cuts. To install it, loosen the bolt on the front of the base. Slip in the rip fence and secure the bolt. [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE MAKITA 4306
Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.
Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual MAKITA 4306 will begin.
