User manual MAKITA 4331D

[. . . ] ENGLISH Cordless Jig Saw MODEL 4331D MODEL 4333D 002700 INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Length of stroke Wood Max. cutting capacities Mild steel Aluminum Strokes per minute (min ) Overall length Net weight Rated voltage 2. 5 kg D. C. 12 V -1 4331D 26 mm 65 mm 10 mm 20 mm 500 - 2, 800 280 mm 4333D 500 - 2, 600 2. 9 kg D. C. [. . . ] Use clamps or another practical way to secure and support the workpiece to a stable platform. Holding the work by hand or against your body leaves it unstable and may lead to loss of control. Ordinary eye or sun glasses are NOT safety glasses. Inspect workpiece for any nails and remove them before operation. Check for the proper clearance beyond the workpiece before cutting so that the blade will not strike the floor, workbench, etc. Make sure the blade is not contacting the workpiece before the switch is turned on. Always switch off and wait for the blade to come to a complete stop before removing the blade from the workpiece. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Always use the correct dust mask/respirator for the material and application you are working with. SAVE THESE INSTRUCTIONS. WARNING: MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. 4 IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. 7. ENC004-1 (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. (3) Do not expose battery cartridge to water or rain. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). [. . . ] The edge of the motor housing indicates the bevel angle by graduations. Then tighten the bolt to secure the base. 2 1. Base 3 002758 Front flush cuts Loosen the bolt on the back of the base with the hex wrench and slide the base all the way back. Then tighten the bolt to secure the base. Cutouts Cutouts can be made with either of two methods A or B. 002763 A) Boring a starting hole For internal cutouts without a lead-in cut from an edge, pre-drill a starting hole 12 mm or more in diameter. [. . . ]