User manual MAKITA 4340CT

[. . . ] Always be sure that the tool is switched off and unplugged before installing or removing the blade. Always clean out all chips or foreign matter adhering to the blade and/or blade holder. Failure to do so may cause insufficient tightening of the blade, resulting in a serious injury. Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. [. . . ] Refer to the table below to select the proper speed for the workpiece to be cut. However, the appropriate speed may differ with the type or thickness of the workpiece. In general, higher speeds will allow you to cut workpieces faster but the service life of the blade will be reduced. CAUTION: Do not look in the light or see the source of light directly. NOTE: Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to scratch the lens of lamp, or it may lower the illumination. Failure to do so may cause blade breakage, resulting in a serious injury. Turn the tool on and wait until the blade attains full speed. Then rest the tool base flat on the workpiece and gently move the tool forward along the previously marked cutting line. When cutting curves, advance the tool very slowly. CAUTION: Always be sure that the tool is switched off and unplugged before tilting the tool base. With the tool base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). 9) Loosen the bolt on the back of the base with the hex wrench. Move the base so that the bolt is positioned in the center of the bevel slot in the base. CAUTION: Always be sure that the tool is switched off and unplugged before installing or removing accessories. When repeatedly cutting widths of 160 mm or less, use of the rip fence will assure fast, clean, straight cuts. To install, insert the rip fence into the rectangular hole on the side of the tool base with the fence guide facing down. When cutting circles or arcs of 170 mm or less in radius, install the rip fence as follows. Insert the rip fence into the rectangular hole on the side of the tool base with the fence guide facing up. Insert the circular guide pin through either of the two holes on the fence guide. Screw the threaded knob onto the pin to secure the pin. now slide the rip fence to the desired cutting radius , and tighten the bolt to secure it in place. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. Ratten för varvtalsreglering kan endast vridas till 5 och tillbaka till 1. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. [. . . ]