User manual MAKITA 4351T

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Length of stroke Wood Cutting capacities Strokes per minute Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. [. . . ] Do not touch the blade or the workpiece immediately after operation; they may be extremely hot and could burn your skin. do not operate the tool at no-load unnecessarily. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. Always use the correct dust mask/respirator for the material and application you are working with. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence to jig saw safety rules. If you use this tool unsafely or incorrectly, you can suffer serious personal injury. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or 3 For clean cuts in wood and plywood. CAUTION: Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. CAUTION: Before plugging in the tool, always be sure that the tool is switched off. This tool can be operated with an orbital or a straight line (up and down) cutting action. The tool speed can be infinitely adjusted between 800 and 2, 800 strokes per minute by turning the adjusting dial. Higher speed is obtained when the dial is turned in the direction of number 5; lower speed is obtained when it is turned in the direction of number 1. refer to the table to select the proper speed for the workpiece to be cut. However, the appropriate speed may differ with the type or thickness of the workpiece. In general, higher speeds will allow you to cut workpieces 4 Faster but the service life of the blade will be reduced. Failure to do so may cause a serious injury. ⷠWhen you remove the saw blade, be careful not to hurt your fingers with the top of the blade or the tips of workpiece. CAUTION: The speed adjusting dial can be turned only as far as 5 and back to 1. Do not force it past 5 or 1, or the speed adjusting function may no longer work. The tools equipped with electronic function are easy to operate because of the following features. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before tilting the base. With the base tilted, you can make bevel cuts at any angle between 0° and 45° (left or right). Loosen the bolt on the back of the base with the hex wrench. Move the base so that the bolt is positioned in the center of the bevel slot in the base. [. . . ]