User manual MAKITA 5007NF

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Cutting depth No load speed (RPM) Overall length Net weight · Note: Specifications may differ from country to country. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. [. . . ] Kickback could cause the saw to jump backwards, but kickback forces can be controlled by the operator, if proper precautions are taken. ⷠWhen blade is binding, or when interrupting a cut for any reason, release the trigger and hold the saw motionless in the material until the blade comes to a complete stop. Never attempt to remove the saw from the work or pull the saw backward while the blade is in motion or kickback may occur. When restarting a saw in the workpiece, centre the saw blade in the kerf and check that saw teeth are not engaged into the material. If saw blade is binding, it may walk up or kickback from the workpiece as the saw is restarted. ⷠSupport large panels to minimise the risk of blade pinching and kickback. Large panels tend to sag under their own weight. Supports must be placed under the panel on both sides, near the line of cut and near the edge of the panel. to minimize the risk of blade pinching and kickback. When cutting operation requires the resting of the saw on the workpiece, the saw should be rested on the larger portion and the smaller piece cut off. To avoid kickback, do support board or panel near the cut. Do not support board or panel away from the cut. Gum and wood pitch hardened on blades slows saw and increases potential for kickback. Keep blade clean by first removing it from tool, then cleaning it with gum and pitch remover, hot water or kerosene. Blade depth and bevel adjusting locking levers must be tight and secure before making cut. If blade adjustment shifts while cutting, it may cause binding and kickback. Use extra caution when making a "plunge cut" into existing walls or other blind areas. The protruding blade may cut objects that can cause kickback. NEVER place your hand or fingers behind the saw. If kickback occurs, the saw could easily jump backwards over your hand, leading to serious personal injury. Push the saw forward at a speed so that the blade cuts without slowing. Check lower guard for proper closing before each use. [. . . ] Both carbon brushes should be replaced at the same time. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. This adjustment has been made at the factory. [. . . ]