User manual MAKITA 5046D 4072D

[. . . ] ENGLISH Cordless Circular Saw with Dust Collection MODEL 5026D MODEL 5036D MODEL 5046D 001322 INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS MODEL Blade diameter Max. Cutting depth No load speed (min ) Overall length Net weight Rated voltage -1 5026D 165 mm 55 mm 2, 400 338 mm 3. 8 kg 5036D 160 mm 53 mm 2, 400 338 mm 3. 8 kg D. C. 18V 5046D 160 mm 53 mm 2, 400 338 mm 3. 8 kg · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] Inspect for and remove all nails from lumber before cutting. Operate with proper hand support and proper workpiece support. WARNING: It is important to support the workpiece properly and to hold the saw firmly to prevent loss of control which could cause personal injury. 4 illustrates typical hand support of the saw. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. 4 A typical illustration of proper hand support and workpiece support. Place the wider portion of the saw base on that part of the workpiece which is solidly supported, not on the section that will fall off when the cut is made. 5 illustrates the RIGHT way to cut off the end of a board, and Fig. If the workpiece is short or small, clamp it down. DON'T TRY TO HOLD SHORT PIECES BY HAND!Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. Using manufacturer data · Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. Ensure that the saw blade is suitable for the spindle speed of the tool. · 21. 5 SAVE THESE INSTRUCTION 5 IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CARTRIDGE 1. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. Do not short the battery cartridge: ENC004-1 (1) Do not touch the terminals with any conductive material. (2) Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. [. . . ] CAUTION: Never use a deformed or cracked blade. When the battery charge runs slow, the blade easily becomes stuck, and the blade tips can break. Always recharge the battery cartridge when the blade rpm slows down. Do not stack materials when cutting them. [. . . ]