User manual MAKITA 5704R

[. . . ] They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. Check operation of lower guard before each use. Don't use if lower guard does not close briskly over saw blade. [. . . ] If the workpiece is short or small, clamp it down. Never attempt to saw with the circular saw held upside down in a vise. This is extremely dangerous and can lead to serious accidents. Before setting the tool down after completing a cut, be sure that the lower (telescoping) guard has closed and the blade has come to a complete stop. Ensure that the diameter, thickness and other characteristics of the saw blade are suitable for the tool. Ensure that the saw blade is suitable for the spindle speed of the tool . Install the saw blade using the reverse of the removal procedure. Install the inner flange, saw blade, outer flange and hex socket head bolt, in that order. Be sure to secure the hex socket head bolt tightly with the shaft lock fully depressed. Make sure that the blade teeth point forward in the same direction as the tool rotation (the arrow on the blade should point in the same direction as the arrow on the tool). Use the correct side for the hole diameter of the blade you intend to use. Mounting the blade on the wrong side can result in dangerous vibration. Use the hex wrench to loosen the hex socket head bolt for the riving knife adjustment, then raise the safety cover. Move the riving knife up or down over the two protruberances for settings indicated in the illustration, so as to obtain the proper clearance between the riving knife and saw blade. CAUTION: Ensure that the riving knife is adjusted such that: The distance between the riving knife and the toothed rim of the saw blade is not more than 5 mm. The toothed rim does not extend more than 5 mm beyond the lower edge of the riving knife. Use a shallow depth of cut when cutting thin workpiece for cleaner, safer cuts. After adjusting the depth of cut, always tighten the lever securely. The following blade can be used with this tool. Loosen the thumb screws in front and back, and tilt the tool to the desired angle for bevel cuts (0° ­ 45°). Secure the thumb screws tightly in front and back after making the adjustment. For straight cuts, align the right notch on the front of the base with your cutting line on the workpiece. [. . . ] (för anslutning till en dammsugare) Koppla en dammsugare till ditt verktyg om du vill ha en ren, dammfri drift. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. [. . . ]