User manual MAKITA 5902B

[. . . ] ENGLISH Circular Saw MODEL 5901B MODEL 5902B 004126 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model Blade diameter at 90° Max. cutting depth at 45° at 50° No load speed (min-1) 5901B 235 mm 85 mm 60 mm 53 mm 4, 100 380 mm 7. 0 kg /II 6. 7 kg /II 5902B Overall length Net weight Safety class · Due to our continuing programme of research and development, the specifications herein are subject to change without notice. · Note: Specifications may differ from country to country. [. . . ] Check operation of lower guard before each use. Don't use if lower guard does not close briskly over saw blade. CAUTION: If saw is dropped, lower guard may be bent, restricting full return. Do not use blades which are deformed or cracked. Do not use blades made of high speed steel. Do not stop the blades by lateral pressure on the saw blade. Sharp blades minimize stalling and kickback. DANGER: Keep Hands Away From Cutting Area. Don't reach underneath work while blade is rotating. Don't attempt to remove cut material when blade is moving. Large panels must be supported as shown in Fig. 1 to minimize the risk of blade pinching and kickback. When cutting operation requires the resting of the saw on the workpiece, the saw shall be rested on the larger portion and the smaller piece cut off. Always use a fence or straight edge guide when ripping. 3. 1 & 3) Kickback occurs when the saw stalls rapidly and is driven back towards the operator. Release switch immediately if blade binds or saw stalls. Use fence or straight edge guide when ripping. Don't remove saw from work during a cut while the blade is moving. NEVER place your hand or fingers behind the saw. If kickback occurs, the saw could easily jump backwards over your hand, possibly causing severe injury. 8. Fig. Lower guard should be retracted manually only for special cuts such as "Compound Cuts". As soon as blade enters the material, lower guard must be released. [. . . ] Secure the lever and the thumb nut clockwise tightly after making adjustment. 1 2 1. Bevel scale plate 004129 Sighting For straight cuts, align the A position on the front of the base with your cutting line. For 45° bevel cuts, align the B position with it. B 1 A 1. Base plate 6 004130 Switch action CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. [. . . ]