User manual MAKITA 6043DWK

[. . . ] Cordless Drill MODEL 6043D INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Capacities Steel / Wood Wood screw 6043D 10 mm (3/8") 4. 5 x 20 mm (3/16" x 3/4") 450/min. 201 mm (7-7/8") 0. 84 kg (1. 9 lbs) Battery Charger DC4100A Input A. [. . . ] Do not charge the tool when temperature is BELOW 10°C (50°F) or ABOVE 40°C (104°F). Do not attempt to use a step-up transformer, an engine generator or DC power receptacle. Do not store the tool in locations where the temperature may reach or exceed 50°C (122°F). 5. Do not incinerate the tool even if it is severely damaged or is completely worn out. Do not charge inside a box or container of any kind. The tool must be placed in a well ventilated area during charging. SAVE THESE INSTRUCTIONS 6 FUNCTIONAL DESCRIPTION 002059 · CAUTION: Always be sure that the tool is switched off before adjusting or checking function on the tool. Charging Connect the charging plug to the charging connector, then plug in the charger to the power receptacle. Charging plug · · · CAUTION: The battery in your new tool is not fully charged. Do not operate the tool during charging. Overcharging more than 2 days considerably shortens the battery service life. Always unplug the charger after completing the charge. 002072 Switch action To start the tool, simply pull the switch trigger. Release the switch trigger to stop. 1 1. Switch trigger 002085 Reversing switch action This tool has a reversing switch to change the direction of rotation. Slide the reversing switch to the right (appear "F" marking) for clockwise rotation or to the left (appear "R" marking) for counterclockwise rotation. CAUTION: · Always check the direction of rotation before operation. · Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. 1 1. Reversing switch 7 ASSEMBLY · CAUTION: Always be sure that the tool is switched off before carrying out any work on the tool. 002112 Installing or removing driver bit or drill bit Hold the ring and turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clockwise to tighten the chuck. To remove the bit, hold the ring and turn the sleeve counterclockwise. 1 3 2 1. Ring OPERATION Screwdriving operation Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. [. . . ] Omaha, NE 68127 (402) 597-2925 OREGON 828 19th Avenue. , N. W. Portland, OR 97209 (503) 222-1823 WASHINGTON 22220 84th Ave. A Kent, WA 98032 (253) 395-8055 KANSAS 8819 W. Overland Park, KS 66212 (913) 642-1111 NEVADA 3375 S. [. . . ]