User manual MAKITA 6096D

[. . . ] Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. [. . . ] the clutch is designed not to slip at the A marking. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. nOTE: · The adjusting ring does not lock when the pointer is positioned only half-way between the graduations. Do not operate the tool with the adjusting ring set between the number 16 and the A marking. Important: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit. Place the point of the driver bit in the screw head and apply pressure to the tool. Start the tool slowly and then increase the speed gradually. Release the trigger as soon as the clutch cuts in. nOTE: · Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged. When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the trigger. Tool speed is increased by increasing pressure on the trigger. Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. move the reversing switch lever to the A position for clockwise rotation or the B position for conterclockwise rotation. When the reversing switch lever is in the neutral position, the tool will not start even if you pull the trigger. To change the speed, first switch off the tool and then slide the speed change lever to the "II" side for high speed or "I" side for low speed. Be sure that the speed change lever is set to the correct position before operation. cAUTION: · Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned half-way between the "I" side and "II" side, the tool may be damaged. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center. Phillips bit Slotted bit Soket bit Drill bit for steel Drill bit for wood Rubber pad assembly Foam polishing pad 125 Wool bonnet 100 Battery cover Various type of Makita genuine batteries and chargers För rotationsomkopplaren till positionen A för medurs rotation, och till positionen B för moturs rotation. [. . . ]