User manual MAKITA 6207D

[. . . ] Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. [. . . ] If it is hard to turn the lever, first turn the chuck slightly in either direction and then turn the lever again. cAUTION: · Always slide the action mode change lever all the way to your desired mode position. If you operate the tool with the lever positioned halfway between the mode symbols, the tool may be damaged. ⷠDo not use the action mode change lever while the tool is running. Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. fIrst , slide the action mode change lever to the position of symbol. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the marking is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. nOTE: · The adjusting ring does not lock when the pointer is positioned only halfway between the graduations. Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. When not using the driver bit, keep it in the bit holders. Place the point of the driver bit in the screw head and apply pressure to the tool. [. . . ] Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. We Makita Corporation as the responsible manufacturer declare that the following Makita machine(s): Designation of Machine: Cordless Driver Drill Model No. / Type: 6207D, 6217D, 6317D, 6337D, 6347D are of series production and Conforms to the following European Directives: 98/37/EC until 28th December 2009 and then with 2006/ 42/EC from 29th December 2009 And are manufactured in accordance with the following standards or standardised documents: EN60745 The technical documentation is kept by our authorized representative in Europe who is: Makita International Europe Ltd, Michigan, Drive, Tongwell, Milton Keynes, MK15 8JD, England For European countries only Noise The typical A-weighted noise level determined according to EN60745: Sound pressure level (LpA): 70 dB (A) or less Uncertainty (K): 3 dB (A) The noise level under working may exceed 80 dB (A). [. . . ]