User manual MAKITA 6213DWBLE

[. . . ] Cordless Driver Drill Equipped with Electric Brake MODEL 6213D INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Steel Capacities Wood Wood screw Machine screw No load speed (RPM) High Low 6213D 10 mm (3/8") 25 mm (1") 6. 4 x 76 mm (1/4" x 3") 6 mm (1/4") 0 - 1, 400/min. 233 mm x 94 mm x 241 mm (9-1/8" x 3-11/16" x 9-1/2") 1. 9 kg (4. 2 lbs) DC1414 A. [. . . ] Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. 1 2 1. Battery cartridge · 004346 Charging 1. Plug the battery charger into the proper AC voltage source. The charging light will flash in green color. 1 2 3 1. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the charger. Insert the cartridge fully into the port so that it rests on the charger port floor. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging. When the charging light color changes from red to green, the charging cycle is complete. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its "trickle charge (maintenance charge)" mode. After charging, unplug the charger from the power source. 8 NOTE: · The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer's batteries. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. If the tool consistently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center. 002086 Reversing switch action This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 1 A B 1. Reversing switch lever · · CAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. [. . . ] 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Dr. Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Ste. 101 San Antonio, TX 78219 (210) 228-0676 MASSACHUSETTS 232 Providence Hwy. Westwood, MA 02090 (781) 461-9754 COLORADO 11839 E. [. . . ]