User manual MAKITA 6216D

[. . . ] 1 2 3 4 5 6 7 8 9 Button Battery cartridge Charging light Battery charger Bit Tighten Sleeve Ring Bit holder 10 11 12 13 14 15 16 17 Switch trigger Reversing switch lever A side B side Clockwise Counterclockwise Low speed High speed 18 19 20 21 22 23 24 25 Speed change lever Adjusting ring Graduations Drill marking Pointer Limit mark Brush holder cap Screwdriver Due to our continuing program of research and development, the specifications herein are subject to change without notice. Note: Specifications may differ from country to country. Safety hints For your own safety, please refer to enclosed safety instructions. Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. [. . . ] If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its "trickle charge (maintenance charge)" mode. After charging, unplug the charger from the power source. Never use it for other purposes or for other manufacturer's batteries. When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge. This is a normal condition and does not indicate a problem. You can recharge the battery cartridge fully after discharging it completely and recharging a couple of times. If you charge a battery cartridge from a just-operated tool or a battery cartridge which has been left in a location exposed to direct sunlight or heat for a long time, the charging light may flash in red color. charging will begin after the battery cartridge cools. The battery cartridge will cool faster if you remove the battery cartridge from the battery charger. If the charging light flashes alternately in green and red color, a problem exists and charging is not possible. The terminals on the charger or battery cartridge are clogged with dust or the battery cartridge is worn out or damaged. Trickle charge (Maintenance charge) If you leave the battery cartridge in the charger to prevent spontaneous discharging after full charge, the charger will switch into its "trickle charge (maintenance charge)" mode and keep the battery cartridge fresh and fully charged. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. Important: Always be sure that the tool is switched off and the battery cartridge is removed before installing or removing the bit. When not using the driver bit, keep it in the bit holders. To change the speed, first switch off the tool and then slide the speed change lever to the " II " side for high speed or " I " side for low speed. Be sure that the speed change lever is set to the correct position before operation. cAUTION: · Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned half-way between the " I " side and " II " side, the tool may be damaged. Do not use the speed change lever while the tool is running. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. [. . . ] These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita service center. [. . . ]