User manual MAKITA 6217D

[. . . ] Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50°C (122°F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. [. . . ] ⷠDo not use the action mode change lever while the tool is running. Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the pointer on the tool body. fIrst , slide the action mode change lever to the position of U symbol. The fastening torque is minimum when the number 1 is aligned with the pointer, and maximum when the marking is aligned with the pointer. The clutch will slip at various torque levels when set at the number 1 to 16. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. cAUTION: · The adjusting ring does not lock when the pointer is positioned only halfway between the graduations. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. to start the tool , simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. When not using the driver bit, keep it in the bit holders. Drilling in metal To prevent the bit from slipping when starting a hole, make an indentation with a center-punch and hammer at the point to be drilled. place the point of the bit in the indentation and start drilling. Use a cutting lubricant when drilling metals. [. . . ] EC-DECLARATION OF CONFORMITY Model; 6207D, 6217D, 6317D, 6337D, 6347D We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents, EN60745, EN55014 in accordance with Council Directives, 2004/108/EC and 98/37/EC. For European countries only For Model 6207D Noise The typical A-weighted noise level determined according to EN60745-2-1: Sound pressure level (LpA): 70 dB (A) or less The noise level under working may exceed 85 dB (A). Vaibration The vibration total value (tri-axial vector sum) determined according to EN60745-2-1: Work mode: Driling into metal Vibration emission (ah, D): 2. For European countries only For Model 6217D, 6317D Noise The typical A-weighted noise level determined according to EN60745-2-1: Sound pressure level (LpA): 72 dB (A) Uncertainty (K): 3 dB (A) The noise level under working may exceed 85 dB (A). [. . . ]