User manual MAKITA 6228DWAE

[. . . ] Cordless Driver Drill Equipped with Electric Brake MODEL 6226D MODEL 6227D MODEL 6228D INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Steel Wood Capacities Wood screw Machine screw No load speed (RPM) Overall length Net weight Battery Cartridge 9120 1220 1420 Voltage 9. 6 V 12 V 14. 4 V High Low 21 mm (13/16") 5. 1 x 38 mm (3/16" x 1-1/2") 6 mm (1/4") 0 - 1, 100/min. 210 mm (8-1/4") 1. 4 kg (3. 1 lbs) Battery Charger DC1290 DC1470 Input 6226D 6227D 10 mm (3/8") 24 mm (15/16") 5. 1 x 63 mm (3/16" x 2-1/2") 6 mm (1/4") 0 - 1, 100/min. [. . . ] To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. 1 2 1. Battery cartridge · · 002063 Charging 1. Plug the battery charger into the proper AC voltage source. Insert the battery cartridge so that the plus and minus terminals on the battery cartridge are on the same sides as their respective markings on the charger. Insert the cartridge fully into the port so that it rests on the charger port floor. When the battery cartridge is inserted, the charging light color will flash in red color and charging will begin. When charging is completed, the charging light goes out. If you leave the battery cartridge in the charger after the charging cycle is complete, the charger will switch into its "trickle charge (maintenance charge)" mode. After charging, unplug the charger from the power source. NOTE: · The battery charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer's batteries. 1 2 3 1. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 1 A B 1. Reversing switch lever 12 14 1. Speed change lever 61 41 16 · · CAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. · 002096 Speed change To change the speed, first switch off the tool and then slide the speed change lever to the "II" side for high speed or "I" side for low speed. [. . . ] 102 Virginia Beach, VA 23455 (757) 460-0280 INDIANA 8403 Michigan Road, Unit 1 Indianapolis, IN 46268 (317) 334-9980 NEBRASKA 4129 S. Omaha, NE 68127 (402) 597-2925 OREGON 828 19th Avenue. , N. W. Portland, OR 97209 (503) 222-1823 WASHINGTON 22220 84th Ave. A Kent, WA 98032 (253) 395-8055 KANSAS 8819 W. [. . . ]