User manual MAKITA 6305

[. . . ] Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. Vibration The vibration total value (tri-axial vector determined according to EN60745-2-1: Work mode: Drilling into metal Vibration emission (ah, D) : 2. Model; 6305 We declare under our sole responsibility that this product is in compliance with the following standards of standardized documents; EN60745, EN55014, EN61000 in accordance with Council Directives, 2004/108/EC, 98/37/EC. [. . . ] To stop the tool from the locked position, pull the switch trigger fully, then release it. 7 Install the side grip assembly so that the teeth on the grip fit in between the protrusions on the tool barrel. Then tighten the grip by turning clockwise at the desired position. It may be swung 360° so as to be secured at any position. nOTE: · The depth gauge cannot be used at the position where the depth gauge strikes against the tool body. 2 The green power-ON indicator lamp lights up when the tool is plugged to the mains. If the indicator lamp is lit but the tool does not start even if the tool is switched ON, the carbon brushes may be worn out, or the motor or the switch may be defective. If the indicator lamp does not light up, the mains cord or the indicator lamp may be defective. When the mains cord is defective, the tool neither starts nor lights the indicator lamp. When the indicator lamp is defective, the tool starts without the indicator lamp lighting up. 9 When drilling a large hole with a hole saw, etc. , the side grip (auxiliary handle) should be used as a brace to maintain safe control of the tool. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Grasp the rear handle and the front grip firmly when starting or stopping the tool, since there is an initial and final reaction. When drilling action is forward (clockwise), the tool should be braced to prevent a counterclockwise reaction if the bit should bind. when reversing , brace the tool to prevent a clockwise reaction. If the bit must be removed from a partially drilled hole, be sure the tool is properly braced before reversing. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. 11 To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized Service Centers, always using Makita replacement parts. Drilling in wood When drilling in wood, the best results are obtained with wood drills equipped with a guide screw. [. . . ] Avoid drilling in material that you suspect contains hidden nails or other things that may cause the bit to bind or break. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. [. . . ]