User manual MAKITA 6305W

[. . . ] If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Use auxiliary handles supplied with the tool. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. [. . . ] V base allows a drill bit to be held perpendicular to workpiece when drilling the workpiece with round section such as steel pipe and the like. Secure V base with screw provided in a box with the tool. The green power-ON indicator lamp lights up when the tool is plugged to the mains. If the indicator lamp is lit but the tool does not start even if the tool is switched ON, the carbon brushes may be worn out, or the motor or the switch may be defective. If the indicator lamp does not light up, the mains cord or the indicator lamp may be defective. When the mains cord is defective, the tool neither starts nor lights the indicator lamp. When the indicator lamp is defective, the tool starts without the indicator lamp lighting up. Stopper - - - screw M 5 x 16 and washer 5 to be used (Fig. 10 & 11) The stopper allows operator to drill a hole with the constant distance away from the workpiece end. Secure the stopper with screw and washer provided in a box with the tool. Sub shoe - - - screw M 6 x 16 to be used (Fig. 12 - 14) Use the sub shoe when the workpiece is unstable as shown in the figures. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. To change the position of the clamper, first push or pull the clamping lever and then move the lever to the desired position. After changing, return the clamping lever to the original position. When changing the position of the clamper, be sure to hold the arm before operating the clamping lever. With the arm held, push or pull the clamping lever so that the arm does not unintentionally move. Place the chuck key in each of the three holes and tighten clockwise. Be sure to tighten all three chuck holes evenly. To remove the bit, turn the chuck key counterclockwise in just one hole, then loosen the chuck by hand. After using the chuck key, be sure to return to the original position. After the clamper is secured, the maximum travel of the drill holder is 47 mm by pulling the grip upward. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose. Base du support - - - utilisez des vis M6 x 14 Levier - - - utilisez des boulons M6 x 10 Retirez la base du support serrée du coffret de transport en métal et fixez-la sur le sabot à l'aide de deux vis. Innan du ansluter maskinen till elnätet ska du kontrollera att avtryckaren fungerar och återgår till läget "OFF" när du släpper den. [. . . ]