User manual MAKITA 6722DW

[. . . ] Do not use tools for purposes not intended. Do not wear loose clothing or jewellery, they can be caught in moving parts. non-skid footwear is recommended when working outdoors. Wear protecting hair covering to contain long hair. [. . . ] Connecting it to any other power source may cause damage to the tool. Do not allow the cordless screwdriver to be exposed to rain or moisture. This symbol indicates that this charger is a Class II appliance and does not require an Earth connection. Recharge only when the tool starts to run slowly. Before the first use, the battery must be charged for 5 hours. New batteries, or a battery that has been stored uncharged for some time, may not initially accept a full charge. The battery should always be charged at ambient air temperatures of between 4° and 40°C. Before the first charge, the battery should be fully discharged. Make sure that the On/Off switch is not activated. After the initial 5 hour charge, the screwdriver will be ready for use. Switch off and remove the charging adaptor from the mains supply and remove the charging plug from the screwdriver. Whilst charging, the battery pack and charger may become warm. This is normal and will continue until the battery is fully charged and the charger has been disconnected from the mains supply. Do not press the On/Off switch when removing, or installing a screwdriver bit. To insert a screwdriver bit, push it firmly into the screwdriver bit holder. To remove a screwdriver bit, pull it firmly out of the screwdriver bit holder. If required the magnetic bit holder supplied with the screwdriver, can be inserted into the screwdriver bit holder and the screwdriver bit can then be inserted into the magnetic bit holder. This cordless screwdriver is supplied with an 80 piece accessory pack. NOTE: Replacement screwdriver bits can be obtained from most tool or DIY stores. Before operating the On/Off switch, make sure that you have read all of the safety instructions on pages 4, 5 and 6. NOTE: Always use sharp good quality screwdriver bits. Using the LED light Press The screwdriver is equipped with an LED light to assist when operating the screwdriver in dark recesses or other poorly lit areas. [. . . ] Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the battery inside the screwdriver is no longer required, it must be disposed of in an environmentally protective way. Take it to your tool dealer or a local recycling centre to be disposed of properly. [. . . ]