User manual MAKITA 6796FD

[. . . ] Do not operate charger with damaged cord or plug -- replace them immediately. Do not operate charger if it has received a sharp blow, been dropped, or otherwise damaged in any way; take it to a qualified serviceman. Do not disassemble charger or battery cartridge; take it to a qualified serviceman when service or repair is required. Incorrect reassembly may result in a risk of electric shock or fire. [. . . ] Use only the driver bit or socket bit shown in the figure below. Do not use any other driver bit or socket bit. Be aware that this tool is always in an operating condition, because it does not have to be plugged into an electrical outlet. Hold tool by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring. Contact with a ``live'' wire will also make exposed metal parts of the tool ``live'' and shock the operator. Be sure no one is below when using the tool in high locations. To install the bit, pull the sleeve in the direction of the arrow and insert the bit into the sleeve as far as it will go. then release the sleeve to secure the bit. To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly. Insert the pins of the adjust grip into the holes in the front of the tool. And then, turn the adjust grip so that the torque gauge shows the desired torque by one of the numbers from 1 to 12. the number provides fastening torque in newtonmeter (N. M), and see below for the standard fastening torque; 6796D/FD: 1 ­ 5 (Nzm) 6797D/FD: 2 ­ 8 (Nzm) 6798D/FD: 6 ­ 12 (Nzm) After completion of the adjustment, always make trial fastening about twenty times in order to keep stability of torque. Then, check the fastening torque with a torque tester before starting operation. Always switch off the tool before insertion or removal of the battery cartridge. ⷠTo remove the battery cartridge, pull out the set plate on the tool and grasp both sides of the cartridge while withdrawing it from the tool. ⷠTo insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Be sure to close the set plate fully before using the tool. ⷠDo not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Before using battery charger, read all instructions and cautionary markings on the battery charger. [. . . ] And so, replace the battery by fully charged one as soon as the red lamp lights up. CAUTION: The lamp may also light up in red before the battery power becomes low under these conditions. ⷠHeavy load under which clutch mechanism does not work. Place the point of the driver bit in the screw head and apply pressure to the tool. [. . . ]