User manual MAKITA 6837

[. . . ] Intended use The tool is intended for screw driving in wood, metal and plastic. Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. Safety hints For your own safety, please refer to the enclosed safety instructions. [. . . ] If the dust cover cannot be moved as far as the plain bearing, try it again after turning the bit slightly. To install the bit, insert it into the socket while turning it slightly. After installing, always make sure that the bit is securely held in place by trying to pull it out. There are 3 positive-lock screw length settings. To obtain the desired setting, pull out the stopper base while depressing the lever until you see the number of the desired screw length (indicated on the plate) appear to rest on the very top edge of the casing. See the table below for the relation between the number indicated on the plate and the respective screw length ranges. Hold the tool squarely against the workpiece and apply forward pressure to the tool. The screw will be automatically carried to the driving position and driven into the workpiece. nOTE: · Do not fire the tool without screws. If the feeder box becomes sluggish in operation, spray car wax (spray type wax) on its sliding surfaces. 17) This tool can be used to drive at a position 15 mm away from the wall as shown in Fig. CAUTION: Driving at a position closer than 15 mm to the wall or driving with the stopper base in contact with the wall may damage the screw heads and cause wear on the bit. This may also lead to poor fastening of screws and malfunction of the tool. While keeping it in this position, turn the adjusting knob until the bit tip projects approx. If the screw head projects above the surface of the workpiece, turn the adjusting knob in the "A" direction; if the screw head is countersunk, turn the adjusting knob in the "B" direction. Squeeze the lock lever with fingers and open the magazine cap. 7) Roll up the screw strip in a form of coil counterclockwise and place it inside the magazine. 8) Run the end of the screw strip on the slotted passage starting from above the magazine. 9) Close the magazine cap while squeezing the lock lever with fingers. 10) Insert the top end of the screw strip into the portion A of the feeder box and feed it in the direction of the arrow. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita service center. Use of extension handle allows you to drive screws into floors while standing. We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. The typical A-weighted sound pressure level is 83 dB (A). [. . . ]