User manual MAKITA 8281DWPE3

[. . . ] If you use this power tool unsafely or incorrectly, you can suffer serious personal injury. Exposure to noise can cause hearing loss. Hold power tools by insulated gripping surfaces when performing an operation where the cutting tool may contact hidden wiring or its own cord. Contact with a “live” wire will make exposed metal parts of the tool “live” and shock the operator. [. . . ] CAUTION: • Always set the ring correctly to your desired mode mark. If you operate the tool with the ring positioned halfway between the mode marks, the tool may be damaged. installing or removing battery cartridge (Fig. 1) • Always switch off the tool before insertion or removal of the battery cartridge. € To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. € To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. € Do not use force when inserting the battery cartridge. If the cartridge does not slide in easily, it is not being inserted correctly. 6) The fastening torque can be adjusted in 16 steps by turning the adjusting ring so that its graduations are aligned with the arrow on the tool body. The fastening torque is minimum when the number 1 is aligned with the arrow, and maximum when the number 16 is aligned with the arrow. Before actual operation, drive a trial screw into your material or a piece of duplicate material to determine which torque level is required for a particular application. 5 ASSEMBLY CAUTION: • Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. NOTE: • When driving wood screws, predrill pilot holes to make driving easier and to prevent splitting of the workpiece. 7) Hold the ring and turn the sleeve counterclockwise to open the chuck jaws. Place the bit in the chuck as far as it will go. Hold the ring firmly and turn the sleeve clockwise to tighten the chuck. To remove the bit, hold the ring and turn the sleeve counterclockwise. OPERATION Hammer drilling operation CAUTION: • There is a tremendous and sudden twisting force exerted on the tool/bit at the time of hole breakthrough, when the hole becomes clogged with chips and particles, or when striking reinforcing rods embedded in the concrete. First, turn the action mode changing ring so that the arrow on the tool body points to the marking. The adjusting ring can be aligned in any torque levels for this operation. [. . . ] If you need any assistance for more details regarding these accessories, ask your local Makita service center. Skub omløbsvælgeren ind fra A siden for omdrejning med uret, og fra B siden for omdrejning mod uret. Skub derefter hastighedsvælgeren helt mod “2” for høj hastighed og helt mod “1” for lav hastighed. FORSIGTIG: • Indstil altid ringen korrekt ud for mærket for den ønskede funktion. [. . . ]