User manual MAKITA 8381D

[. . . ] WARNING: For your personal safety, READ and UNDERSTAND before using. Model Steel Wood Capacities Concrete Wood screw Machine screw No load speed (RPM) Blows per minute Overall length Net weight Rated voltage Standard battery cartridges High Low High Low 210 mm (8-1/4") 1. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. â· Note: Specifications may differ from country to country. [. . . ] Contact with a "live" wire will make exposed metal parts of the tool "live" and shock the operator. Be sure no one is below when using the tool in high locations. Do not touch the bit or the workpiece immediately after operation; they may be extremely hot and could burn your skin. Some material contains chemicals which may be toxic. Take caution to prevent dust inhalation and skin contact. MISUSE or failure to follow the safety rules stated in this instruction manual may cause serious personal injury. Volts direct current no load speed revolutions or reciprocation per minute number of blow Do not short the battery cartridge: (1) Do not touch the terminals with any conductive material. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. the battery cartridge can explode in a fire. Be careful not to drop or strike battery. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Always cover the battery terminals with the battery cover when the battery cartridge is not used. CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before adjusting or checking function on the tool. Always switch off the tool before insertion or removal of the battery cartridge. To remove the battery cartridge, withdraw it from the tool while pressing the buttons on both sides of the cartridge. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. [. . . ] CAUTION: Always be sure that the tool is switched off and the battery cartridge is removed before carrying out any work on the tool. After drilling the hole, use the blow-out bulb to clean the dust out of the hole. Use a cutting lubricant when drilling metals. The exceptions are iron and brass which should be drilled dry. [. . . ]