User manual MAKITA 8443DWDE

[. . . ] Cordless PercussionDriver Drill Equipped with Electric Brake MODEL 8413D MODEL 8433D MODEL 8443D INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. w w w. c o m SPECIFICATIONS Model Concrete Steel Capacities Wood Wood screw Machine screw No load speed (RPM) Blows per minute Overall length Net weight High Low High Low 8413D 13 mm (1/2") 13 mm (1/2") 8433D 14 mm (9/16") 13 mm (1/2") 8443D 16 mm (5/8") 13 mm (1/2") 38 mm (1-1/2") 10 mm x 90 mm (3/8" x 3-1/2") 6 mm (1/4") 0 - 1, 400/min. 0 - 21, 000 0 - 6, 750 30 mm (1-3/16") 36 mm (1-7/16") 6 mm x 75 mm (1/4" x 3") 6 mm (1/4") 0 - 1, 300/min. [. . . ] Insert the cartridge fully into the port so that it rests on the charger port floor. When the battery cartridge is inserted, the charging light color will change from green to red and charging will begin. The charging light will remain lit steadily during charging. Let a hot battery cartridge cool down before charging it. Charge the Nickel Metal Hydride battery cartridge when you do not use it for more than six months. 9 002404 Switch action · CAUTION: Before inserting the battery cartridge into the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. 1 1. Switch trigger To start the tool, simply pull the switch trigger. Tool speed is increased by increasing pressure on the switch trigger. Release the switch trigger to stop. Electric brake This tool is equipped with an electric brake. If the tool consistently fails to quickly stop after switch trigger release, have tool serviced at a Makita service center. 002409 Reversing switch action This tool has a reversing switch to change the direction of rotation. Depress the reversing switch lever from the A side for clockwise rotation or from the B side for counterclockwise rotation. When the reversing switch lever is in the neutral position, the switch trigger cannot be pulled. 1 A B 1. Reversing switch lever · · CAUTION: Always check the direction of rotation before operation. Use the reversing switch only after the tool comes to a complete stop. Changing the direction of rotation before the tool stops may damage the tool. When not operating the tool, always set the reversing switch lever to the neutral position. · 002414 Speed change To change the speed, first switch off the tool and then slide the speed change lever to the "II" side for high speed or "I" side for low speed. Be sure that the speed change lever is set to the correct position before operation. Use the right speed for your job. 1 1. Speed change lever 10 · CAUTION: Always set the speed change lever fully to the correct position. If you operate the tool with the speed change lever positioned halfway between the "I" side and "II" side, the tool may be damaged. Do not use the speed change lever while the tool is running. The tool may be damaged. · 002419 Selecting the action mode This tool employs an action mode changing ring. Select one of the three modes suitable for your work needs by using this ring. 1 2 1. [. . . ] 809 Farmers Branch, TX 75234 (972) 243-1150 12701 Directors Dr. Stafford, TX 77477-3701 (281) 565-8665 3453 IH-35 North, Ste. 101 San Antonio, TX 78219 (210) 228-0676 MASSACHUSETTS 232 Providence Hwy. Westwood, MA 02090 (781) 461-9754 COLORADO 11839 E. [. . . ]