User manual MAKITA 9036

[. . . ] Symbols The following show the symbols used for the tool. Be sure that you understand their meaning before use. Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the "OFF" position when released. For continuous operation, pull the trigger and then push in the lock button. To stop the tool from the locked position, pull the trigger fully, then release it. This tool has not been waterproofed, so do not use water on the workpiece surface. Ventilate your work area adequately when you perform sanding operations. Always use the correct dust mask/respirator for the material and application you are working with. Turn the tool on and wait until it attains full speed. then gently place the tool on the workpiece surface. A finishing sander is generally used to remove only a small amount of material at a time. Since the quality of the surface is more important than the amount of stock removed, do not bear down on the tool. Keep the base flush with the workpiece at all times. Excessive pressure may damage the paper and shorten tool life. You can put a high polish on furniture or other fine surfaces by using a cloth under the tool. cAUTION: · Do not block motor vent with your finger or hand. [. . . ] EC-DECLARATION OF CONFORMITY We declare under our sole responsibility that this product is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. The typical A-weighted sound pressure level is 79 dB (A). The noise level under working may exceed 85 dB (A). [. . . ]