User manual MAKITA 9060DBL

[. . . ] Angle Sander MODEL 9060DBL 001015 DOUBLE INSULATION INSTRUCTION MANUAL WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. SPECIFICATIONS Model No load speed (RPM) Overall length Net weight Spindle thread 9060DBL 6, 000/min 458 mm (18") 4. 2 kg (9. 3 lbs) 5/8" · Manufacturer reserves the right to change specifications without notice. · Specifications may differ from country to country. GENERAL SAFETY RULES (For All Tools) USA002-2 WARNING: Read and understand all instructions. Failure to follow all instructions listed below, may result in electric shock, fire and/or serious personal injury. SAVE THESE INSTRUCTIONS Work Area 1. [. . . ] Ordinary eye or sun glasses are NOT safety glasses. Use only flanges specified for this tool. NEVER use tool with wood cutting blades or other sawblades. Such blades when used on a sander frequently kick and cause loss of control leading to personal injury. Be careful not to damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. 4 9. Make sure the abrasive disc or the wheel is not contacting the workpiece before the switch is turned on. Hold the tool so that sparks fly away from you and other persons or flammable materials. Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin. Ventilate your work area adequately when you perform sanding operations. ALWAYS wear proper apparel including long sleeve shirts, leather gloves and shop aprons to protect skin from contact with hot grindings. Use of this tool to grind or sand some products, paints and wood could expose user to dust containing hazardous substances. Use appropriate respiratory protection. IF USED AS A GRINDER 16. Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments. When using depressed center grinding wheels, be sure to use only fiberglassreinforced wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Run the tool (with guard) at no load for about a minute, holding tool away from others. If wheel is flawed, it will likely separate during this test. Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could indicate poor installation or a poorly balanced wheel. [. . . ] When using wire wheel brush, avoid applying too much pressure which causes over bending of wires, leading to premature breakage. MAINTENANCE 001170 1 CAUTION: · Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. 2 1. Inhalation vent The tool and its air vents have to be kept clean. Regularly clean the tool's air vents or whenever the vents start to become obstructed. 001146 Replacing carbon brushes When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced. [. . . ]