User manual MAKITA 9079S

[. . . ] 25 Ohms it can be presumed that there will be no negative effects. The mains socket used for this device must be protected with a fuse or protective circuit breaker having slow tripping characteristics. Safety hints For your own safety, please refer to the enclosed safety instructions. Always wear safety goggles and ear protectors during operation. [. . . ] CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. , Australia, New Zealand, France, Réunion and Algeria To prevent the trigger from being accidentally actuated, a lock lever is provided. To start the tool, push the lock lever in the arrow direction and then pull the trigger. For Germany, Austria, Italy, Switzerland, Netherlands, Belgium, Spain, Portugal, Denmark, Sweden, Norway, Finland, Greece, Russia and South Africa To prevent the trigger from being accidentally actuated, a lock lever is provided. To start the tool, push the lock lever in the arrow direction and then pull the trigger. For continuous operation, push the lock lever in the arrow direction, pull the trigger and then push the lock lever further in the arrow direction. To stop the tool from the locked position, pull the trigger fully, then release it. For all other countries To start the tool, simply pull the trigger. For continuous operation, pull the trigger and then push the lock lever in the arrow direction. To stop the tool from the locked position, pull the trigger fully, then release it. NOTE: Models 9077S, 9077SL and 9079S begin to run slowly when they are turned on. This soft start feature assures smoother operation and less operator fatigue. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wheel guard. When installing a depressed center wheel or an abrasive cut-off wheel, always use a wheel guard. Mount the wheel guard with the protrusion on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard 180 degrees clockwise. tighten the lever to fasten the wheel guard. If the lever is too tight or too loose to fasten the wheel guard, loosen or tighten the screw to adjust the tightening of the wheel guard band. Important: Always be sure that the tool is switched off and unplugged before installing or removing the side grip. Always install the side grip on the tool securely before operation. The side grip can be installed in any of three positions on the sides of the tool, whichever is convenient and keeps the guard properly positioned. Always hold the tool's switch handle and the side grip firmly with both hands during operation. [. . . ] CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. When the resin insulating tip inside the carbon brush is exposed to contact the commutator, it will automatically shut off the motor. When this occurs, both carbon brushes should be replaced at the same time. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. [. . . ]