User manual MAKITA 9217SPC

[. . . ] Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other accessories running over rated speed can fly apart and cause injury. Check the backing pad carefully for cracks, damage or deformity before operation. [. . . ] The side grip can be installed on either side of the tool. Important: Always be sure that the tool is switched off and unplugged before installing or removing the disc. Fit the disc on over the rubber pad and screw the lock nut onto the spindle. Hold the spindle firmly with the wrench and tighten the lock nut using the lock nut wrench. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. Keep the abrasive disc at an angle of about 10° ­ 15° to the workpiece surface. Excessive pressure will result in poor performance and premature wear to the abrasive disc. Press the trigger and at the same time push the lock button. To stop this lock position, press the trigger and release it. Important: Always be sure that the tool is switched off and unplugged before installing or removing the wool bonnet. Hold the spindle firmly with the wrench and tighten the lock nut using the lock nut wrench. fit the wool bonnet over the rubber pad. Tie a bow knot and tuck the knot and any loose strings between the wool bonnet and the rubber pad. 3) The tool speed can be changed by moving the speed change switch to the ``L'' position or ``H'' position. High speed (3, 800 min-1): For sanding operation Low speed (2, 000 min-1): For polishing operation CAUTION: Use the speed change switch only after the tool comes to a complete stop. 4) The tool speed can be infinitely adjusted between 1, 500 rpm and 2, 800 rpm by turning the speed change knob. Refer to the table below for relationship between the number settings on the knob and the approx. Keep the wool bonnet at an angle of about 10° ­ 15° to the workpiece surface. [. . . ] The accessories or attachments should be used only in the proper and intended manner. : series production) manufactured by Makita Corporation in Japan is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. The typical A-weighted sound pressure level is 83 dB (A). [. . . ]