User manual MAKITA 9526PB

[. . . ] If in doubt, wear the protective equipment. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglassreinforced wheels. [. . . ] If working place is extremely hot and humid, or badly polluted by conductive dust, use a shortcircuit breaker (30 mA) to assure operator safety. Do not use the tool on any materials containing asbestos. Ensure that ventilation openings are kept clear when working in dusty conditions. If it should become necessary to clear dust, first disconnect the tool from the mains supply (use non metallic objects) and avoid damaging internal parts. When use cut-off wheel, always work with the dust collecting wheel guard required by domestic regulation. Cutting discs must not be subjected to any lateral pressure. Mount the wheel guard with the tab on the wheel guard band aligned with the notch on the bearing box. Then rotate the wheel guard 180° clockwise (for 9526PB) or counterclockwise (for 9527PB and 9528PB). CAUTION: Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. Replace when they wear down to the limit mark. Keep the carbon brushes clean and free to slip in the holders. Both carbon brushes should be replaced at the same time. Take out the worn carbon brushes, insert the new ones and secure the brush holder caps. To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or adjustment should be performed by Makita Authorized or Factory Service Centers, always using Makita replacement parts. For your own safety always use the side grip. The side grip can be installed on either side of the tool. CAUTION: Always be sure that the tool is switched off and unplugged before installing or removing the wheel. mount the inner flange onto the spindle. Fit the wheel on over the inner flange and screw the lock nut onto the spindle. 4) To tighten the lock nut, press the shaft lock firmly so that the spindle cannot revolve, then use the lock nut wrench and securely tighten clockwise. 5) WARNING: Only actuate the shaft lock when the spindle is not moving. Do not pull the switch trigger forcibly without pushing in the lock-off button. [. . . ] Rondeller med försänkt nav bör inte användas efter att de har slitits ner till 75 mm i diameter för modell 9526PB, eller till 90 mm för modellerna 9527PB och 9528PB. Kontrollera alltid att strömbrytaren fungerar normalt och återgår till det avstängda läget ("OFF") när den släpps, innan du sätter i kontakten till maskinen. CAUTION: These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. [. . . ]