User manual MAKITA 9555N

[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. For European countries only Noise and Vibration The typical A-weighted sound pressure level is 84 dB (A). The noise level under working may exceed 85 dB (A) ­ Wear ear protection. [. . . ] When tool is used outdoors, use only extension cords intended for outdoor use. Before further use of the tool, a guard or other part that is damaged should be carefully checked to determine that it will operate properly and perform its intended function. Check for alignment of moving parts, free running of moving parts, breakage of parts, mounting and any other conditions that may affect its operation. A guard or other part that is damaged should be properly repaired or replaced by an authorized service center unless otherwise indicated in this instruction manual. Have defective switches replaced by an authorized service facility. Do not use the tool if the switch does not turn it on and off. The use of any accessory or attachment, other than those recommended in this instruction manual or the catalog, may present a risk of personal injury. Have your tool repaired by a qualified person. This electric tool is in accordance with the relevant safety requirements. Repairs should only be carried out by qualified persons using original spare parts, otherwise this may result in considerable danger to the user. 3. Other personal protective equipment such as dust mask, gloves, helmet and apron should be worn. Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Use only wheels with correct size and wheels having a maximum operating speed at least as high as the highest No Load Speed marked on the tool's nameplate. When using depressed center wheels, be sure to use only fiberglassreinforced wheels. Check the wheel carefully for cracks or damage before operation. Replace cracked or damaged wheel immediately. Observe the instructions of the manufacturer for correct mounting and use of wheels. Do not use separate reducing bushings or adaptors to adapt large hole abrasive wheels. Use only flanges specified for this tool. Do not damage the spindle, the flange (especially the installing surface) or the lock nut. Damage to these parts could result in wheel breakage. Make sure the wheel is not contacting the workpiece before the switch is turned on. [. . . ] Shaft lock 6 OPERATION · · · · · WARNING: It should never be necessary to force the tool. The weight of the tool applies adequate pressure. Forcing and excessive pressure could cause dangerous wheel breakage. ALWAYS replace wheel if tool is dropped while grinding. [. . . ]